SOURCE: oil pan removal on 2002 gmc sierra
did you pull the rubber plugs between the motor and trans out? there are either nuts or bolts up there
SOURCE: egr valve on a 2002 Saturn SL1
Take off air breather tube,you should see a cone shaped part, on top and at back of engine right by the gas pedal cable. Remove the 2 10mm bolts, and it should come right off.
SOURCE: Need to get unmoveable crank pulley holding bolt out, '97 subie
Some use a three prong puller. Not very hard to use and you can rent them at auto zone or advance. If an impact wrench isn't getting it off you might wanna try a good size socket wrench with an impact socket. then use a large pipe and a hammer. hit it firmly a few times then try to turn then hammer again then turn again until it breaks loose.
SOURCE: Idiot question, lacate oil pan, I'm haven't change oil 20 yrs
I don't want to sign up for the plan right now. I'm still having the problem, I think that the oil plug has been tighten so much, thats why I'm having the problem. I just want to make sure its the oil plug. My question is, is the oil pan in front of the transmission oil pan?
Fig. Fig. 1: Oil pan installation-1995 2.2L OHV engine shown
To install:
Fig. Fig. 2: After removing the oil pan, inspect the gasket. If it's not damaged you can reuse it
To install:
Fig. Fig. 3: Oil pan tightening specifications-2.3L and 2.4L engines
25 views
Usually answered in minutes!
×