Cruse control just stopped working fuses seem to be ok what else could be the problem
Hi,
Appreciate the "Ask Me".
To my knowledge, Cruise Control would be relatively difficult to diagnose without a scan tool attached to the control module to read the error codes. Additionally, car versions in my country seldom have such a device since our roads are narrower and travel distance is not that great.
Though most known causes are:
Other possible components to check are:
As posted above, quite a number of possibilities. Any other indications, speedometer OK; abnormal throttle responses; abnormal idling, brake light always ON, slack in the accelerator/gas pedal? Was it cutting in/out before? Was there any recent repair work done on the engine before the cruise control cut out?
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards. Thank you for using FixYa.
Louie, thanks so very much for this wealth of information. I do not know if you received more questions from me that i sent to you, new to the site so not sure what/where to post thanks and more questions. I suppose this is it.
Where is the vacuum line to actuator (most likely), vacuum actuator, diaphragm, control valve? Up close the top of the engine? I will look around. And WILL find it. I do not like to let things beat me haha. Thanks again for all the help!!!...Daniel
×
1,528 views
Usually answered in minutes!
I have a 99 chevy c/k truck and my cruse control just stopped working. The fuse's are good. I was told by a chevy dealership that it is the brake swtich. where is the brake switch and how hard is it to replace?
Phil
2007 vw touareg ruse control stoped working is there a fuse ?
2007 vw touareg is thera fuse for the cruse control?
To Louie Role: Daniel Day, concerning the cruse control - thank you so much for all of the possible solutions.
Back 40+ years I street raced, etc and did most of my own work. These days, even with my 2004, it is like reading Greek to know where anything is.
You mentioned "most likely": vacuum line to the Actuator, diaphragm, control valve. I don't even know where that is. I imaging on the engine close to the throttle linkage? Am I close? Where could I go to get a picture or diagram of that so I know what I should be looking at?
I cannot thank you enough for your taking the time to help me, Your awesome!
Thanks again, Daniel
×