Direction/turn signal relay location

You have one flasher for your turn signals and one for your emergency flashers. If one turn signal works then it isn't your flasher. I would look at the connector under the bed where the trailer plug splits off. This is a common place for corrosion. With a 12v test light you can probe from the light for power. If there isn't anything at the connector at the light move up to the splitter. If you have a signal there your problem is between it and the tail light.

Chevrolet Express Questions - 2011 Brake and turn fuse ...

www.cargurus.com > Questions > Chevrolet > Express

CarGurusJan 23, 2011 - 2011 Brake and turn fuse - Were is the fuse for brake and turn on ...location). and two sets of fuses for the brake and turn signal lamps, one in eachlocation. ... i mean for 2006 express extended van .... in fuel pump plug and its hot always even if you pull fuse and relay. ... Used Chevrolet Express Cargo".

Ford E-Series Cargo Questions - Where is the turn signal ...

www.cargurus.com > Questions > Ford > E-Series Cargo

CarGurusWhere is the turn signal relay on a 2010 e350 located - I need to replace the turn signal relay, where is it located? ... Asked by dogfoodman Sep 24, 2013 at 08:38 AM about the 2007 Ford E-Series Cargo E-350 Super Duty ... Used GMC Savana Cargo". 43 Great ... Copyright © 2006-2015 CarGurus ®, Inc., All Rights Reserved.

LOCATION OF THE TURN SIGNAL RELAY? - Fixya

Look near the fuse panel and you will see a cylinder (about an inch in circumfrence) this is your blinker relay. Usually there is a seperate one for flashers and one for blinkers. I am not sure that it would make your front flashers illuminate.

Your flasher relay is most likely bad. your emergency flashers work on a seporate relay than your turn signals.

This sounds like your turn signal relay is sticking. If it is sticking it does not matter the position of your turn signal arm. Check the relay. It will be in your fuse box under the hood.

To find the FLASHER on 1994 GMC Truck C1500 1/2ton Sub 2WD 5.7L TBI 8cyl. the Flasher is located: Front seating area, driver side, under dash, driver side of steering column, mounted in relay bracket

Application: Hazard flasher

Turn SIgnal flasher is one independent unit.

Hope helps-

There are a row of Allen head and 9/16 nut screws on the bottom panel below the steering wheel and middle panel, remove those.
Gently pull down lower panel, upper panel will pull out as well slightly. The hazard flasher (left) and turn signal (right) are just to the left of the lighter assembly. (Silver)Relays are difficult to pull out, if you gently use wide mouth pliers , rock them out. Replace and test, before reinstalling panel.
Thank you for using fixya and be safe

Replace the Turn Signal Flasher Relay. It has 2 relays. One for the Hazard lights and one for the Turn Signals. The Turn Signal Flasher Relay is located Front seating area, driver side, passenger side of steering column, under dash, mounted near cigarette lighter. Optional mounting location is under dash, on driver side of steering column. (Curtorsey Auto Zone)

the brake lights and the rear turn signals should be the same bulb check the bulbs to make sure they are not blown does your third brake light work if all brake light are out and the bulbs are good check the brake light switch on the brake pedal

You May need to replace the turn signal Switch/lever assembly on your car , do the turn signals work at all ? if they don't try the 4 way flasher , if the 4 way flasher's work suspect the turn signal switch .

Hope this helps