What is the gap for a spark plug on a 2004 gmc envoy?

this shows info and repair for the p0526 its basically the fan clutch but on an envoy and trailblazers their electronic- prices vary but if this code popped up after changing plugs check the connections and harness for disconnect or damage ---recheck the plugs that the coil s are good and wires are on tight https://www.youtube.com/watch?v=UxwUvTiqtTA

Natalie, our 4.2 engine only likes 1 sparkplug. AC Delco 41-103. This Iridium plug comes pre-gapped, to near the specs Mike posted. Don't try and gap these particular plugs yourself, easy to ruin them.

check for proper seating of coils / plug gap and connectors around the throttle body for possible accidental disconnect or damage

Which engine ? 4.8L, 5.3L, and 6.0L or 4.2 L

correction this is a 4.2L not a 2.4L
Do a 2004 GMC Envoy Slt 2.4L have a ignition module?
The engine will turn but want start no spark at the spark plugs boot what could be the cause no spark? AmanStino 3 USB ports Car charger with 1 Type port AmanStino

Assuming you are talking about the 6 cylinder engine, the spark plugs are under a cover on top of the engine. There is a coil pack on top of each spark plug, the plugs are recessed in the valve cover.

On he very top of your engine, there will be six coil pack, they all look the same, from front to rear of engine, remove 10mm bolt, disconnect elec. harness, pull coil pack out, spark plug will be in there, do one at a time, this is the spark plug gap .044"

bad coil number 5 or spark plug is bad change the plug first see if it helps if not change the coil make sure the engine is cold can warp head if not check gap and use aintsize hope this helps you

I have a 2004 GMC envoy with a V8 and its not to hard the drivers side plugs are not to bad to get to but the passanger side is a little tricky you have to go through the wheele well to get at them also the spark plug boot are really on there tight and were hard to remove them

they come pre gapped with collars to prevent the electrodes from getting bent .platinum and iridium plugs will have the surface damaged if you were to adjust them with a feeler gauge,like old plugs had to be gapped. ac or ngk plugs come pre gapped in the box.