TO clean the throtle plate use a small tooth brush and some throtle body cleaner. remove the intake hose, spray the throtlebody and then open the throtle plate and spray plate , use brush to clean body and plate then spray clean try not to spray to much into engine , after its clean then start the engine you may have to hold gas pedal down to start as it going to be a little load up with fuel from the cleaner, some time sit will start up on its on and run a little rough for a few seconds and clear up. As far as the mass sensor this needs to be cleaned with mass air flow cleaner, this is a spray like the throtle spray but is made for that sensor and drys fast, spray the two sensors inside but dont touch them or move them spray as close to them as you can to clean them, good luck.
208 views
Usually answered in minutes!
×