What problems will come with a 1990 Honda Accord with a passenger wheel turned in? Is it the axle? Should I purchase a car with this problem?

They can break, but they give plenty of warning signs before they do. Clicking or knocking when making a slow turn, Vibrations going down the road. The rubber boots on each end will sling grease, before they break. If by chance the shaft broke, it was a defective part.

check tire pressure and alignement.

sounds like bent axle on rear.i would have it checked.

make sure they connect the speed sensor back
there is a sensor on the passenger's side
near the passenger's side inner axle boot

Broken ball joint.

No, you don't have to pull the engine. Many of those problems are fixed by removing the wheel, and the plastic inner fender. It's probably a crank seal, or a power steering hose. PS- You mean the passenger side... don't you?

If you are referring to the axle nut on the end of the axle shaft, you may need an impact wrench, or make sure to bend the nut back (straighten out the bent section), put the car on the ground with the wheel on, and use a breaker bar, with a 3 foot piece of pipe attached (cheater bar) to loosen it. REMEMBER - some of these are reverse thread, if so you will have to go clockwise to loosen and CCW to tighten, thus, you MAY be tightening it - check the thread on the end of the shaft to tell you what way to turn the nut - if it still won't come off then you may have to use some heat, and/or chemical penetrants, but make sure you are turning it the correct way first...

yes my cv axles had to be replace cause of the same thing but when you replace one side you need to do the other side at the same time cause when 1 goes bad the other is not that far behind . i know from experience

My 2003 honda accord was doing this too. The problem is the inner CV axle bearings. The fix is to replace both CV axles. When you choose your CV axle choose a new one not a reman, there are known problems with used CV axles. It's not a hard job. It took me 1hr to do both sides on a lift.

1990 Honda Accord tail lights are not working.I have checked all the fuses and the bulbs.Everything is good.Front headlights are working,same with the signal lights.what do I need to check next.