You will need a code tester to be hooked up to the aldl link normally located under the instrument panel, close to steering wheel, and the code tester reads codes that the computer has picked up, evidently something has been recognized by the computer for the light to come on, you need to find out what the trouble code is and fix the problem, also code tester can remove the light from being on. auto part stores can test your saturn with a code tester. and if the problem has already been repaired, and you want the light off, auto part stores tester will remove it. hope that this information has been helpful.
You want to make the light go away?
You have no interest in properly
diagnosing and repairing a system
malfunction on your vehicle, that
set the light?
You referring to clearing codes
There are no resets on vehicles
SOURCE: service engine soon light on 2003 Saturn Vue
Here is the definition of the code in GM manual:
P0128 - Coolant Thermostat Below Thermostat Regulating Temperature, this indicates the engine is running cold, u need a thermostat
SOURCE: 2003 saturn vue service light on with wrench how
Open the hood. You will notice there is a large black box on the right-hand side directly behind the battery. This black box is the fuse box. Pull the top of the fuse box off. There are two clips on either side; once you pop one side, the other comes off very easily. In the top left-hand side of the fuse box where all the fuses sit, you will see a large orange/red block. Below this block is a button that says "reset." Press this button for 5 seconds. Turn the car on and wait for a minute. If the light does not go on, turn off the car and set the key to ACC on the key ring. Push the reset button again, holding it for a total of 15 seconds. Turn the key to off, take out the key, return the key and start the car again. Allow the car to run for 2 full minutes. It is taking the system a few minutes to register that this button has been pressed.
SOURCE: Service Engine light on Green line 2007 Saturn Vue
take the ground line of the battery and press the brake for a few minutes and if the life is still on have the vehicle scann and clear code and have the emission components for the vehicle check
1,054 views
Usually answered in minutes!
×