Automatic Transmission, 32RH Initial Fill..........4.1 quarts
Automatic Transmission, 30RH Initial Fill..........4.1 quarts
Automatic Transmission, Total Fill
3 speed 32RH..........8.6 quarts
3 speed 30RH..........7 quarts
Manual Transmission, AX-5 2WD..........7.4 pints
Manual Transmission, AX-15 2WD..........6.8 pints
Manual Transmission, AX-15 4WD..........6.8 pints
SOURCE: need to change manual transmission fluid
pull the lower plug from the transmission, it will be on the bottom or the side on the bottom. replace the plug after draining and remove the fill plug wich is about half way up the side of the transmission. use 75w 90 gear oil in the trans.
good luck
SOURCE: manual transmission fluid leak. Where do I find the fill hole
check passenger side of transmission - it is a 3/8 ext that will fit the bolt - does not really look like a regular fill hole -
SOURCE: Dont know were to put in new transmission oil on a 1992 Jeep Wrangler
It's on the passenger side of your transmission, around half way down. after draining your fluid, fill untill fluid comes out where your putting it in
SOURCE: Change transmission fluide in 1999 Jeep Cherokee
Flush is Recomended Here as Changing Fluid can get Messy
SOURCE: What type of oil,oil filter and transmission fluid
Jeep Wrangler/YJ 1987-1995 Repair Guide
Engine Oil
Fig. 1: Be sure to select the proper API quality classification and SAE viscosity grade of engine oil (10W-30)
Oil FIlter (K&N sample)
HP-2004 work for 2.5L and 4.0L
Manual Transmission
The level of lubricant in the transmission should be maintained at the
filler hole on all manual transmissions. This hole is on the right
side. When you check the level in the transmission, make sure that the
vehicle is level so that you get a true reading. When you remove the
filler plug, lubricant should run out of the hole. Replace the plug
quickly for a minimum loss of lubricant. If lubricant does not run out
of the hole when the plug is removed, lubricant should be added until
it does. Replace the plug as soon as the lubricant reaches the level of
the hole.
Fig. 1: Manual transmission fill and drain hole plugs
DRAIN AND REFILL
Remove the drain
plug which is at the bottom of the transmission. Allow all the
lubricant to run out before replacing the plug. Replace the case with
the correct viscosity oil. All manual transmissions use SAE 75W-90 API
quality Grade GL-5 gear lubricant. Tighten the fill hole plug to 27 ft.
lbs. (37 Nm).
I hope help you with this (rermember rated this help) Good luck.
Testimonial: "thank you, great advice, came in handy"
1,864 views
Usually answered in minutes!
Automatic or manual?
×