HI...........
If you can give me the axact YEAR, I can help you with that.
Thank you. for use fixya.
Thank for Rate. But if I NOT gave any solution to your problem.
DON'T rate. because a THANKS FOR TRYING, Is NEGATIVE FEED BACK..
when I ask. for your YEAR was 24. and you Posted the Year 30. And maybe Rate 30.
FIxya is getting problem with the SYStem.
I'm Apologize , But a I saw this comment on my Profile Just Today 07 aug.
BUT I HAVE YOUR SOLUTION...
1--------- Turn the key to ON position.
2--------- Press and hold pressed the TRIP Button.
3--------- While pressing the trip button turn the key to ACC
Position for 10 Seconds.
4----------Them turn the key to RUN position for 10 seconds or
UNtil the MAINT LIGHT go OFF " some cases more
Than 10 seconds..... and you will ready.
NOTE Remember with the TRIP button pressed all the time.
If you RESET with this step .. Please come BACK and RATE as FIXYA. Thank you........
×
2008 honda pilot how do I rest the service light on the dash
SOURCE: Maintenance Required light
The light needs to be reset. Usually after an oil change they will reset it for you. Directions for doing yourself>>> turn off the engine, press and hold the select/reset button in the instrument panel then turn the ignition switch on. Hold the button until the indicator resets (approximately ten seconds). Directions from your Honda manual. Hope this helps!
SOURCE: maitneance required light
Hi.. after you do this step come back and rate as fixya. OK..
Turn the ignitio key to run position
Push and hold for 5 seconds the Trip reset botom.
With the botom pushed turn the ignition key to OFF position.
Keeping pushed the botom.
Turn the Ignition switch to RUN position. keep pushed the trip botom for 10 seconds or untill you see the MAINT_Requi. go OFF.
Remember all this steps with the trip botom pushed. OK.
I hope this solve your question. Thank you for use fixya.
SOURCE: Maintenance Required light on after dead battery
No its easy . here are the steps turn ignition to acc/ first turn hold reset button located next to odometer rest button. Hold this button for 30 seconds. then turn ignition to next turn/click where lights come on on the dash ex brake air bag etc. hold for another 30 seconds. The maintenance light should flash and go out start vehicle and your maintenance is done. Good luck ad thanks for using FIX YA
621 views
Usually answered in minutes!
Everytime I have my 2006 Honda CRV serviced they cannot reset the maintenance light. They don't know how at the service center I use. (Not a Honda dealer) Anyway I can do this myself?
Maintenance Required light was not reset after last service. How do I reset it?
×