Compliance bushings are shot Honda Knows of this Problem and are trying to keep it on the down low. !!!!!!!!!!!
SOURCE: Front end shimmy
check steering linkage for loosness, sterring wheel free play(may be too excessive), front wheel balancing?
SOURCE: Shaking Car
Front end alignment. Worn and loose wheel,idler arm, tie rod ends , ball joints and or pitman arm. Have front end alignment and parts tested or get under unit and start moving the parts and see what is loose then replace it/them. Most likely is the idler arm.You will still have to have the front end realigned after relacing worn, loose, parts.
SOURCE: loud noise/bang from the back of the car when going over bumps
You more than likely have one of two problems. One of your shock absorbers has a broken attachment bracket or 2) You have a broken exhaust bracket to your muffler. To check the shock just have the vehicle on a flat area motor turned off with emergency brake on and go to each side and "bounce" the vehicle using your body weight. Then to check the exhaust do this when motor is completely cool motor off emergency brake on and chock the tires so there is no chance the vehicle will roll. Get under the rear and attempt to move the exhaust assembly. If it moves to any degree side to side etc then it is this. If the vehicle bounces excessively when you bounce on it then it is the shock - repair accordingly. Hope this helps.
SOURCE: car shut off after hitting lg. pothole
Hi
It should be by the drivers door foot-well.
If its not that, could be the cam sensor.
Good Luck !
Please give me a FixYa rating.
John.
1,544 views
Usually answered in minutes!
I have the same exact problem. Two trips to Honda says everything is tight in the suspension but they agree there is a noise there. Have you fixed it?
×