SOURCE: MY 1998 RAM 2500 (5.9
The problem is caused by electrical noise making the torque convertor go in and out of lock up. The dodge dealer has a computer flash for it. The fash only works about 30% of the time. This is a major problem to diag. Usually requires ground straps installed on pcm or pcm replacement could also be the altenator, wiring, or anything that runs to the pcm or tranny.
SOURCE: engine runs rough at certain speeds 3.0 v6 flex-fuel 1999 ranger
Check and see if the EGR valve is leaking, to check this spray water on it at idle, if the water steams off the valve is leaking and is the source of your problem, also are you sure you hooked the new DPFE sensor up right? re-check it..
SOURCE: Truck jerks hard in overdrive
its just time for a tune up
what your getting at low RPMs is just a misfire. i would bet to say that you engine light is also on.
so plugs and clean your throttle body and if you haven yet replace your fuel filter.
later paul
SOURCE: When traveling between 35-55 mph. my pathfinder
You got a problem a sense on the accerlator .Or on the air intake senser.If it's not that I would put gas cleaner in the tank.That would be the cheaps thing to try. Buy your gas at walmart and in the insle that has the tech gas cleaner and buy it there ,it will install it has you pump.
475 views
Usually answered in minutes!
×