1996 Jeep Grand Cherokee Laredo, no start,
They have crankshaft sencers on the transmission on jeeps. it would be up high on the drivers side on front of transmission. they will cause it to not get fuel or fire and can run then quit.
I HAD THE SAME PROBLEM I HAD TO CHANGE THE INJECTORS FOR SOME REASON THEY WENT BAD
Ok it has nothing to do with the gear box
no ower to your injectors check engine fuse
if and wen u took the gear box out did take the positive lead off?
if u did unplug the computer or try the reset so the computer can no the car is back togeather
Unlock all of the Jeep Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.
Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.
Control any distant PC remotely. Test the Software now for Free!
www.TeamViewer.com/Remote_Control
Point the remote at the receiver (located by the little bulb on the car ceiling) and hold down the "Lock" button for up to 5 seconds.
When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.
Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!
1,536 views
Usually answered in minutes!
fuses all check OK
have tryed to reset computer by disconnecting positive and negative leads for as long as 24 hour >> still no go...
is it advisable to swap the computer out of the parts vehicle..?
×