-
Expert
375 Answers
- Posted on Jan 24, 2011
Re: Blower motor wont come on.how hard is it to replace
It's not that hard to do here are some general directions on how it i
- Disconnect the negative battery cable.
- Disconnect the blower motor lead connector from the wiring harness connector.
- Remove the blower motor cooling tube from the blower motor.
- Remove the four retaining screws.
- Turn the motor and the wheel assembly slightly to the right so that the bottom edge of the mounting plate follows the contour of the wheel well splash panel.
- Lift up on the blower and remove it from the blower housing.
- Installation the new blower motor by reversing the removal steps.
- Connect the negative battery cable.
s done!
×