SOURCE: remove a cd player from a Chevrolet Aveo
the stereo bracket is bolted in. To get to the bolts you must remove the trim. There is a nice long trim piece on both sides of the stereo that extend down to the cup holders. Work a credit card under the pointed edge and pull outward. It will pop loose with a little effort. Then you can pop it loose from its top by pulling on the trim piece itself. This will expose a half a dozen bolts. Use a socket wrench on a bit driver to reach the deeper two. Once the bolts are unscrewed, the whole radio bracket will be loose and you can pretty much figure it out from there. Just a factory harness to disconect and an antennae wire and a few small screws (maybe).
SOURCE: 2008 Chevrolet Aveo Car Radio
remove the trim around the radio. that goes down to the cup holders. take it out by removing the screws. and wires
SOURCE: Clicking noise when brake is applied
sounds like what is happening is one of your wheel speed sensors is dropping out when you slow down and this is triggering abs unit. it would not cut abs light on because system thinks one wheel is locking up just like when you are on ice. need to read data while driving and see what is going on when it activates.
SOURCE: 2002 lincoln ls shakes hard when the brakes are applied
yes you do replace them both and have the new ones checked before you install them,alot of the cheap ones have been stacked and stored incorrectly causing warpage even before you get them,have a good day DB
SOURCE: Right side trailer brake light does not work
Did yo check the fuse panel inside the truck its located on the drivers side dash , you have to open the driver side door, in there is a 10 amp fuse that is linked to rt trailer brakes and rt turn signal for the trailer, if the fuse is good there is a black box under the dash located on the floor on the driver side, just to the left of the break, thats where must of the plug in wire harness is for the trailer breaks!
110 views
Usually answered in minutes!
×