Removal & Installation
2.4L Engine
To Remove:
To Install:
3.3L & 3.8L Engines
To Remove:
To Install:
Sorry, I just noticed that was for a 2006 Dodge Caravan.
The next post will be for the 2006 Dodge Grand Caravan.
I think the instructions are the same as they share the same engine.
Removal & Installation
2.4L Engine
To Remove: Disconnect the negative battery cable.
Disconnect the intake air temperature sensor and remove the air cleaner assembly.
Remove the EVAP purge solenoid and move it out of the way.
Disconnect the wiring from the alternator.
Remove the accessory drive belt from the alternator.
Remove the alternator.
To Install: Install the alternator.
Install the accessory drive belt
Connect the wiring to the alternator.
Install the EVAP purge solenoid in the bracket.
Install the air cleaner and duct, then connect the intake air temperature sensor.
Connect the negative battery cable.
3.3L & 3.8L Engines
To Remove: Disconnect the negative battery cable.
Disconnect the wiring from the alternator.
Raise and safely support the vehicle.
Remove the right front tire and lower splash shield.
Remove accessory drive belt.
Remove the lower engine oil dipstick tube bolt, then remove the wiring harness from the dipstick tube.
Remove the 3 mounting bolts.
Lower the vehicle.
Remove engine oil dipstick tube.
Roll and carefully remove the alternator from vehicle.
To Install: Place the alternator into position on the engine.
Install upper mounting bolts to hold the alternator in place.
Lubricate the o-ring with engine oil and install the dipstick tube.
Install the upper dipstick tube bolt.
Connect the wiring to the alternator.
Raise and safely support the vehicle.
Install the alternator lower mounting bolt and tighten.
Install the lower oil dip stick tube bolt.
Install the accessory drive belt.
Install the right front splash shield and tire.
Lower vehicle.
Install the wiring harness at the dipstick tube
Connect the negative battery cable.
×
SOURCE: i want to replace altenator
If you don't want to ask a dealers parts people
in person,ask an auto parts store
Obviously they have to be exactly the same
SOURCE: 2006 dodge grand caravan 38000 mi. grinding noise
remove the road wheel and inspect your brake pads or shoes, possibly worn down to metal
SOURCE: how to install egr valve on 2006 dodge grand
You cannot clean them purchase a new one and pull the old one out of the valve cover, and disconnect the hose that runs to it. install the hose on to the new egr with a new worm clamp and push the other end into the valve cover. should take about 10 minutes.
SOURCE: how do you remove the water pump from a 2006 dodge
drain coolant loosen water pump pulley bolts, take off serpentine belt, finish removing pulley, unbolt water pump (5 bolts) and remove scrap off old gasket silicone new gasket to new water pump and reverse steps for installation
SOURCE: 2006 Grand Caravan: Can't get pcv valve from a 3.8 dodge grand caravan...
I just replaced mine and had the same problem. If you look at the new one, you should find a small hole at the base of the metal tube. Using a mirror, I located the same hole in the one in the valve cover and inserted a pointed awl into it and was able to pry it out. Do it slowly since you are prying against plastic. When inserting the new one, I found that it should not be inserted as far the original one was and has a gentle snap.
3,845 views
Usually answered in minutes!
×