SOURCE: Engine over-revs between 2nd and 3rd gear
they did not install bands right needs to be rebuild bands need to be adjusted
SOURCE: 95 gran marchis trany; shifting
The transmission needs to have the filter and fluid replaced.
SOURCE: Loss of power in 92 4x4 nissan truck
it seems to me that your air flow meter needs to be replaced.
SOURCE: 1992 accord (d4) light stays on and only have 2nd and overdrive
Same problem, only 2nd and 4th gears (92 ex, auto with 175k). Missed diagnosed by previous mechanics, replaced engine coolant sensor. Couldn't figure that one out? Went back because problem reoccured within a week and now much worse than before. They diagnosed as bad TCM this time and want over $700 to fix, in addition to the other $300 I spent. Said a resister was burnt on the board. Did not believe them. I pulled the board myself (located under the pass. floor mat, disconnect battery, remove four screws and pull the wiring out and open it up). Looked at board myself did not see anything wrong, but does not mean that it isn't bad. Research on the web said that it might be a bad release solenoid on the shift handle? It's located in the center console underneath the plastic covering near the park brake. That checked out ok. So I ordered a TCM from allcomputerresources.com ($155) should be here in a couple of days. I hope this helps me and you. Good luck.
639 views
Usually answered in minutes!
×