There is very limited information to determine the nature of your problem. Probable or possible solutions to your problem are as follows; you may have a bad window switch or the hardware pertaining your window is damaged. If you do not hear the window motor gyrating a noise then the motor is bad, the switch is bad or components pertaining to the window guide is bad.
Good Luck
?€¢
Passenger Door Module (PDM)
?€¢
Body Control Module (BCM)
?€¢
RR power window switch
?€¢
Window up and window down relays in each of the rear passenger window switches
?€¢
Window lockout switch
?€¢
Reversible power window motors in each of the doors (circuit breaker protected)
?€¢
LT DOOR CB 25A (System power for left windows)
?€¢
RT DOOR CB 25A (System power for right windows)
The DDM contains four power window switches which are integral components. Closing any of the normally open, rocker type switches provides the DDM with a request for power window operation. The switches for the two front windows have three positions UP, Down and Express Down, while the switches for the rear windows have only two positions, UP and Down. Each of these switches and their positions is a direct input into the DDM. Upon receiving a request for power window operation, the DDM, transmits a Class 2 message indicating the switch and it's changed position.
The PDM contains a single power window switch that is an integral component. Closing of this normally open, rocker switch provides the PDM with a request for the front passenger power window operation. The switch for the front passenger window has two positions Up and Down. Each of these switch positions is a direct input to the PDM.
The two rear passenger doors have there own switches. Each of the switches contain a power window up and down relay. A switch activation alone can control the up and down functions of the rear windows. However the BCM, upon receiving a Class 2 message from the DDM, can control the set of relays which will activate the rear window motors.
You need a scan tool to diagnose these systems
Power Window Inoperative - Driver Door
1
Did you perform the Door Systems Diagnostic System Check?
Go to Step 2
Go to Diagnostic System Check - Door Systems
2
Operate the driver power window in the UP and DOWN directions.
Does the driver power window operate properly?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
Go to Step 3
3
Before you replace anything, inspect the connector pins in both the driver's door switch and the passenger door switch. If you don't find any problem with these connector pins, replace the driver's door control switch.
75 views
Usually answered in minutes!
×