Take help of the following steps to remove rear bumper on ur tucson.
Open the trunk of your vehicle.
Squat behind your car and firmly pull the bumper off. There
will popping plastic sounds, this is the pop-in-place plastic rivets
that are the last pieces that hold your rear bumper in place.
Remove the tailgate package. Remove both rear lights. Remove the cover over the door lock receiver (two screws, pull straight up) Remove mud patches (three screws and a plastic plug / screw below) Then there is a screw on the left rear wheel houses. Dnne sits inside a hole in the rear edge. Remove all plastic plugs and screws you see above and below. Bumper is now free. Lytt til Les fonetisk Ordbok - Vis detaljert ordbokresultat
SOURCE: how to remove the back
you have to remove the intake plenum to access the rear plugs on the engine. it sounds rough but it is not that hard .just be sure to disconnect the sensors before pulling up on the plenum so not to damage them.
2,214 views
Usually answered in minutes!
×