I lost my ignition key what do I do - 1994 Ford Crown Victoria

you damaged the ignition switch and it will not recognize key you have to replace the tumbler and ignition switch the key acts like an electronic switch in most modern vehicles put key in and its recolonized and will turn and start vehicle ---damage to key or tumbler sets off anti theft and you have no start ---in future dont try to hot wire or pop ignition when keys are lost (thats all hollywood) go to dealer with vin and proof of ownership and they can cut you a new key

the key fob? or radio remove or what?
remote to what.

the operators manual covers this , under car keys.
the car came with 2 Fobs. lost them both now>?
RKE its called, (makes looking fact more easy)
is this car with SKIS Immoblizer option> yes./no
if yes.
SENTRY KEY IMMOBILIZER SYSTEM - IF
EQUIPPED
im reading your operators guide now.
lost that too>?
Duplication of keys may
be performed at an authorized dealer (or locksmiths) or by using the
Customer Key Programming procedure.

DIY, takes 1 key , good, called a valid key, in the below text.
You can program new keys to the system if you have two
valid keys by doing the following:
1. Cut the additional Sentry Key Transponder blank(s) to
match the ignition switch lock cylinder key code.
2. Insert the first valid key into the ignition switch and
turn the ignition switch ON for at least 3 seconds but no
longer than 15 seconds. Turn the ignition switch OFF and
remove the first key.
3. Insert the second valid key and turn the ignition
switch ON within 15 seconds. After ten seconds, a chime
will sound and the SKIS indicator light will begin to
flash. Turn the ignition switch OFF and remove the
second key.
4. Insert a blank Sentry Key into the ignition switch and
turn the ignition switch ON within 60 seconds. After 10
seconds, a single chime will sound. The SKIS indicator
light will stop flashing, turn on for 3 seconds; then turn
off.
The new Sentry Key has been programmed. Repeat this
process to program up to a total of 8 keys.


did i guess right, the Key FOB RKE,
remove key entry fob.?

Have to see the dealer & also have an owners manual
to change the codes to what you want on the door

Ignition keys you lost?

You should have at least three keys programmed to
the ignition key detector system (First)

to reprogram new key first you need to use 2 factory program keys.place first factory key in the ignition first turn ignition on for 3 seconds. then turn off ignition then install second factory in the ignition on position for 10 seconds.when immobilizer warning lamp begins to flash a acoustic signal is emitted.within 60 seconds. switch ignition off and remove key.then insert new key and switch on for 10 seconds a acoustic signal is emitted and immobilizer warning lamp remain illuminated for 3 seconds indicating programming completed.if all fails dealership has to reprogram new keys.

A key code is stamped on the lock cylinder to aid in replacing lost keys.

try going to your dealer to see about getting a new key first

that sucks....

A locksmith can come and pull your ignition switch and make a key for it, if you have AAA
I think they pick up part of the cost.

be for you replace ignition key. try going to a ford dealer.bring your reg and see if they can punch a key out for you. if not try to find a lock smith to make a key.if no luck you can replace it the switch cost about $25.00