Hi
I have 2007 model of Suzuki GV in India. It has 2.0 L engine with 120 HP and 170 Nm of peak torque. At RPM below 2000 the car really struggles sometimes. Can you suggest in expensive modification that can increase low RPM torque
Thanks
rajul
SOURCE: suzuki grand vitara 2000 model the engine light blinks
Take your rig.. drive it to a gas station.. fill the tank up with gas.. also fill 2 jugs of gasoline at the same time... put the jugs in the back of it.. now drive as far as you can until the rig runs out of gas.. then, take the two jugs of gas.. pour it all over the rig, inside and out.. now light it a-blaze, then walk to your nearest car dealer and buy a new car..
SOURCE: Suzuki GV towing electrics
You would need to purchase a 3-2 converter to wire a towing harness on there. The Vitara Function-Colors are as follows.
SOURCE: i need a torque specifications for acylinder head
You can get that information and a lot more with free registration at www.autozone.com
SOURCE: wats the torque setting on the head bolts on a
Install cylinder head to block.
After applying oil to
cylinder head bolts, tighten them gradually
as follows.
(1)Tighten all bolts to 53 N.m (5.3 kg-m,
38.5 lb-ft) according to
numerical order in sequence
(2)In the same manner as in (1), tighten
them to 84 N.m
(8.4 kg-m, 61.0 lb-ft).
(3) Loosen all bolts until tightening torque is reduced to 0 in
reverse
order of tightening.
(4)In the same manner as in (1), tighten them to 53 N.m
(5.3 kg-m, 38.5 lb-ft).
(5) In the same manner as in (1) again, tighten them to
specified
torque....105 N.m (10.5 kg-m, 76.0 lb-ft)
This was taken from SQ416 manual from www.suzukinfo.com
I hope this helps.
166 views
Usually answered in minutes!
×