To begin with, if you are revving a cold engine to 6000 RPM, you are asking for a blown engine. Most OBD vehicles are equipped with a rev limiter that will cut off fuel at 3000 to 4000 rpm to prevent you from over-revving your engine and blowing it up. If yours is revving to 6000 RPM cold, then the rev limiter, for some reason is not working while it is cold. I have no explaination for this. The best thing I can tell you is to stop revving your engine so high when it is cold unless you really want to see what an engine looks like after is has gone off like a grenade.
1. Start the engine when the engine coolant
temperature gauge needle points to C. Allow
the engine to idle until the gauge needle
points between the C and H (normal operating
temperature).
2. Accelerate the vehicle to 55 MPH (88
km/h), then quickly release the accelerator
pedal completely and keep it released for at
least 6 seconds.
3. Quickly depress the accelerator pedal for a
moment, then drive the vehicle at a speed
of 53 to 60 MPH (86 to 96 km/h) for at least
5 minutes.
4. Stop the vehicle.
5. Accelerate the vehicle to 35 MPH (55 km/h)
and maintain the speed for 20 seconds.
6. Repeat steps 4 through 5 at least 3 times.
7. Accelerate the vehicle to 55 MPH (88 km/h)
and maintain the speed for at least 3 minutes.
8. Stop the vehicle and turn the engine off.
9. Repeat steps 1 through 8 at least one more
time.
If step 1 through 7 is interrupted, repeat the
preceding step. Any safe driving mode is acceptable
between steps. Do not stop the engine
until step 7 is completed. If you cannot or
do not want to perform the driving pattern, a
NISSAN dealer can conduct it for you.
948 views
Usually answered in minutes!
×