Sounds like low speed coil in the Blower Fan resistor block has failed. The Blower Fan Resistor Block is usually located in the air ducting adjacent to the Blower Fan. The Resistor Block consists of 3 or 4 coils of special resistance wire attached to terminals which connect to the wiring that comes from the fan switch and then to the Blower Fan. The block is on the output side of the fan unit so that the airflow from the fan past the coils inside the duct assists in preventing them from overheating and burning out.
Access to the Resistor Block is from under the dash. To replace, remove the multi-pin connector and then undo the screws holding in the block. Check air duct for leaves and dirt which may have caused the coils to fail. .Replacement is the reverse procedure
2,003 views
Usually answered in minutes!
×