I have a 320d se tourer, 2005, with no warning buzzer when leaving lights on and no sound sort of ticking/clicking sound when indicator is used? (used to call flasher unit in the old days)
is it me and this is how it is, or have I a problem,
only occured when yesterday my battery was flat because I had left my lights on, just wished I had a warnings buzzer.
any advice would be very much appreciated,
cheers,
SOURCE: loss ofpower bmw 320d tourer 51plate
99 percent sure its your max airflow meter i had the same problem with my 325ci petrol model
SOURCE: warning light
HELLO MATE
IVE GOT THE MANUAL AND THAT LIGHT IS YA COOLANT LEVEL IS LOW TOP UP WITH COOLANT RUN FOR 5 MINS SWITCH OFF WAIT A COUPLE MINS THEN START AGAIN
STEVE
SOURCE: run flat tyre warning light is on i have checked tyre pressure
This will only come on when a tyre has dropped in pressure (not spare). It work on the principle that a tyre with less air has a smaller rolling circumference and therefore a different wheel speed. This is then monitored against other signals from other wheels and determined that a loss in pressure has occured.
If all tyre pressures seem ok, there could be a chance of a small unoticeable leak and would require a bath test. This is when the tyre is dipped in water and bubbles would appear where the puncture is.
Ultimately the system may just need to be reset, or has incorrectly been reset from a tyre change. For this you just press and hold the TPC button (located on the centre console above the gearstick - looks like a flat tyre with an exclamation) turn on the ignition to position 2 and the light will come on re then yellow,go out, come back on yellow. When it comes back on yellow it re-initializing the system. You can let go of the button and after 20 odd seconds the light will go out for the final time, completing the reset.
If the light continues to come on after the reset then you definitely have a puncture somewhere!
Hope this helps!
SOURCE: I have a bmw 3 series touring 320d se 2000 x. I'm
try fitting a new rubber door seal to the rear door.
SOURCE: BMW 320D,2006- run flat tyre warning light is on. How do I reset?
Using the indicator stalk, navigate to the tyre pressure reset option, press the reset button twice in short succession but hold it in the second time until a tick appears on the display
48 views
Usually answered in minutes!
×