Which is cylinder # 1 on a 2000 2.4 pontiac motor if you are looking at it from the front??? is it the first cylinder on the pass side???

the firing order is 1-2-3-4-5-6, with #1 being pass side front cylinder, unless you're overseas, where it's the driver's side front cylinder. Either way, the #1 cylinder is still the one closest to the front of the engine.

2.2 ecotec motor?

The oil filter is located under the oil filter cap located on the drivers side front of the motor. Remove the plastic cover that goes over the top of the engine. As your standing in front of the vehicle look down and just to the right of the intake manifold. You will see a black plastic cap about 3" in diameter. It will have what looks like a large bolt head molded into the top of it. Remove that cap and the oil filter will be under it.



I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Front cylinder drivers side

1,2,3,4, Pass Side
5,6,7,8, Driver Side
Front to Back

firing order is 142536
looking at front of car the motor the belts to the pass side
cylinders will look like this
pass 123 coil pack is a little wierd on this car 4pin
side 456 connector

123
564

if your looking at the front of the truck! pass side from front to back! 1357 drivers side front to back 2468

1992 Pontiac Firebird
3.1 liter V-6

Did you bleed the master cylinder before you put it in the vehicle?This usually makes it easier to bleed the entire brake system if this is done before you install the master cylinder.Other wise all you have done is put air in the brake system.The master cylinder kit usually comes with a bleeder kit.This is for bench bleeding the master.Hope this helps.Good luck.

I can narrow it down for you. Usually #1 is in front on the passenger side. Number 2 would be next on the passenger side. Can't verify because after search I jump out of your case.

Try changing the switches over.change the diver switch over to passenger then go from there.