2001 Saturn L-Series Logo
Posted on Oct 05, 2010
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

I have one wiper that does not work the other stops in the middle of the windshield how can i fix them

2 Answers

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Brigadier General:

An expert that has over 10,000 points.

  • Master 3,911 Answers
  • Posted on Oct 05, 2010
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Brigadier General:

An expert that has over 10,000 points.

Joined: Feb 14, 2009
Answers
3911
Questions
3
Helped
985043
Points
10712

I have left two sets of instructions for replacing the wiper motor and/or transmission on here for Saturn L series. Search around, I am not going to repeat them again, it is not hard and they tend to go bad. Also it is such a common problem I would think someone would have left a video over on www.youtube.com

Duane Wong

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Saturn Master 6,826 Answers
  • Posted on Oct 05, 2010
Duane Wong
Saturn Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Jun 20, 2010
Answers
6826
Questions
6
Helped
2860988
Points
20234

The motor could be bad, but it's likely that the ball joint connections under the hood area under the cowl have become disconnected for the one windshield wiper arm.

The connection of the arm that moves should be checked for being at the correct angle for parking.
Removal & Installation 2000-03 Wiper Motor and Bushing Replacement L4-2.2L (Vin F) & V6-3.0L (Vin R) To Remove:
i have one wiper that does not work the other - sat_car_22_fw-wpr_arm_xp.gif

  1. Before servicing the vehicle refer to the precautions at the beginning of this section
  2. Remove the wiper arm finish caps
  3. Mark both wiper arm positions on the windshield by using a wax pencil or tape
  4. Remove or disconnect the following:
    • Wiper arm retaining nuts and washers
    • Wiper arms
    • Weather-strip at rear of hood sat_car_22_f_wshd_wthr-strp.gif

      sat_car_22_f_wshd_gril_nts.gif

    • Grill nuts from base of wiper arm shaft
    • Grill
    • Electrical harness connector from the wiper motor
    • Wiper motor retaining bolts
    • Wiper motor assembly from plenum area
    sat_car_22_f_wpr-mtr_asy.gifsat_car_19_wpr_mdl_rmv.gif

  5. If replacing wiper module bushings remove the steel bushing first then the rubber grommet
  6. Remove the wiper motor from the transmission assembly
To Install:
  1. Install or connect the following:
    • Wiper motor to transmission assembly NOTE: If the wiper module bushings were replaced install the rubber grommet first then the steel bushing.
    • Wiper motor to plenum area
    • Wiper motor retaining bolts; torque to 44 lb-in. (5 Nm)
    • Electrical harness connector to the wiper motor
    • Weather-strip at the rear of hood
    • Grill
    • Grill nuts to the base of the wiper arm shaft
  2. Install the wiper arm assemblies at the marks made during removal or at the PARK position if a new wiper motor is installed
  3. Install the wiper arm retaining washers and nuts; torque to 9 lb-ft. (12 Nm)
  4. Ini have one wiper that does not work the other - prev.gife wiper arm finish caps
  5. Verify correct wiper system operation
prev.gif next.gif

Ad

3 Related Answers

Jerry Parmanand

  • 449 Answers
  • Posted on Dec 17, 2008

SOURCE: Windshield wipers will not turn off & the day lights not working

switch is bad change it. have a nice day

Ad

Anonymous

  • 3911 Answers
  • Posted on Sep 02, 2009

SOURCE: Windsheild wiper park position in Saturn 2000 LS1

I had the same problem in my LW200. As the other poster indicated a new wiper motor will do the trick. This is an easy fix. Remove the wiper arms, pry up the plastic center cap and remove the nuts holding the arms down then pull them off. A soft prying nudge from underneath will help as they are splined shafts. Raise the hood, put a large deep well socket on over the splined shafts and remove the 2 large nuts holding the trim panel on. Pull up and off the long rubber which runs along the front of the trim panel, watch there is a sharp edge underneath. Now you can gently pull off the trim panel, remembering to lift it over the splined shafts. Mechanism is right there, remove 3 screws and unplug wiring. Take wiper motor off the linkage swap with a new one at advance auto, about 100 bucks, reinstall in reverse order. Note there is a stamping on the linkage telling you where the pivot arm should be for the rest or stopped position and if you ignore that your wipers will be out of whack. While you are in there you may want to change the cabin air filter as well.

Anonymous

  • 2 Answers
  • Posted on Apr 11, 2010

SOURCE: 2000 Saturn LS, windshield wipers park in the

The wipers are parking in the middle because the timing mechanism is off. Once they start doing this it seems to continue to happen so the 1st suggestion is to replace the wiper motor. If U don't want to spend the $ right now it's a pretty easy fix to reset the timing. Park the wipers & remove the wiper arms. Then remove the plastic cowling that covers the wiper motor & the motor assembly. Turn the wiper assembly over without turning the motor. Remove the nut on the arm of the motor. Repostion the arm pointing away from the closet wiper directly inline with the short arm. reassemble.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

2005 mercury mountaineer windshield wipers stopped working in the middle of the windshield. ..the rear windshield wiper works though

That really sounds like a fuse blew for the wipers.
Check your owners manual for fuse box location.
Please let me know if this helps
1helpful
1answer

2005 mercury mountainer windshield wipers won't work at all the rear windshield wiper works...the front windshield wipers just stopped in the middle of the wind shield

sounds like a wiper motor or might be a bad ground try to tap on the wiper motor with a hamer and is it starts to move you will need to replace it
1helpful
2answers

Wipers don't work in high speed and when intermittent wipers are set they stop in the middle of the windshield.

Yes that is likely a switch problem. Before you buy any parts have a shop confirm my guess.
0helpful
1answer

Windshield wipers park in middle of windshield

wipers park in middle of w/shield, take off and replace in rest on windshield ( stop at were you want them to stop).
0helpful
1answer
0helpful
1answer

Wipers automaticly turn and stop in the middle of windshield

Bad circuit board. Can't think of the name. Someone familiar with your veh will tell us. Any repair shop can fix it for you
Don't ever push on the wiper arms or you'll damage the linkage
2helpful
1answer

2006 kia wipper works but stops in the middle of the windshield

It sounds like the the circuit board has gone bad and does not know where the base is any more so it will stop at the middle or the windshield. Auto Zone should have a new board if it's replaceable like the GM products. Good luck and hope this helps, In the mean time you can always turn your wipers on and pull the fuse out when it's at the down position so it's not up.
3helpful
1answer

Windshield wipers stuck upright when off

This is a commoon problem with what is called the "Park pawl stop". The tab is most likely bent and needs to be re-aligned, then the wipers need to be re-timed. This re-timing can be a little difficult, although the re-aligning of the tab is failry simple.

TechJK
Not finding what you are looking for?

893 views

Ask a Question

Usually answered in minutes!

Top Saturn Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...