How can I replace replace the plastic panel housing with the drivers seat adjustment controls on my 2003 Honda Pilot?? The screw that held it in place is still there but the plastic paneling being held by the screw has broken away from the panel. I have removed the old one but I can't figure out how to get the drivers seat adjustment control separated from the panel!!!!

SOURCE: remove plastic cover around top of steering column on '05 Accord

1. The wire you need are not going to be in the columm. They are going to be under the collumm, under the dashboard.
2. Also if you have a microchip in your key, the remote start will not work. Unless you take a spare key with a microchip in it, and tie it with a paperclip to amplify the chip, inside the steering columm or close to it. (because the microchip key doesn't necessarily need to be inside the ignition) so when you use the wireless starter, the computer will think the microchip key is being used.

SOURCE: driver power seat

Yes, that piece is called the "recline cover". You will need the trim color code from the vehicle identification plate on the inside driver's door frame to match the trim plastic color. This is going to be a dealer part or perhaps an ebay part but make sure the trim color is a match.

SOURCE: The power swich to move the seats to my Honda

YOU CAN PUT A POWER AND EARTH TO THE SWITCH WIRES

SOURCE: 2003 honda civic how to remove door panel

Step one Look at the inside door handle. Behind it you should see a little cover, You pop that off and there will be 2 phillips head screws behind it. remove them.

Pop out the door handle, and unplug the power lock plug,

Youll also have to take the door lock rod, by spinning the plastic door handle 90 degrees until u can wiggle it out.

next remove the sail panel( The little triangle shaped piece in the corner of the door on the top, ( may have a tweeter in it) ( it just pops out)

Next take a screwdriver (flat head) and pry off the cover of the door handle, there will be
2 phillips head screw behind it ( remove screws)

Unplug power window connector (big green plug)

Now just start gently pry the door panel off with a screw driver, see if u can peek behind the panel and see where the panel clips are, and pry near those areas

SOURCE: Honda Civic 2003. I need to separate (disassemble)

There might be hidden screws , usually at door handle , pluged with round plastic caps , or at door opening handle with small round cap.Look around and see what you can find .