SOURCE: ABS/traction control 1998 lincoln towncar
sounds like the brake pads may be metal to metal, that could be the noise problem, but until u have the system tested for the trouble code that is setin the ABS modules memory when the light comes on you are guessing, the Dealer is the only one in most cases that has the scan tool to check ABS trouble codes.
Testimonial: "That the last thing I wanted to here but "dealership" but the truth sometimes hurt. Not the brakes though (clanking noise)"
SOURCE: 2004 lincoln ls 3.0 abs light and traction control
have the car scanned with a scanner capable of reading ABS codes,get back to me with the code and we'll go from there. sounds like like one of the wheel sensors is bad. this controls both ABS and TRACTION CONTROL
SOURCE: abs light, trac light, service engine soon light 2001 Pontiac Grand Am
Sounds like you have a bad wheel speed sensor. You need to have it scanned. Since it's been sitting, it might just be a bad connection to one of the speed sensors.
SOURCE: Impala - trac off and ABS light along with service traction syst
THE PROBLEM IS WITH A HUB WHEEL SPEED SENSOR OR MORE LIKELY THE HARNESS LEADING TO THE HUB.
CHECK THE RESISTANCE AT THE HUB CONNECTION, IT SHOULD BE BETWEEN 900OHMS AND 1300OHMS. THEN SWITCH TO A-C VOLTAGE, IT SHOULD BE 100MV WHEN TURNING THE WHEEL BY HAND. IF BOTH CHECK OUT THE PROBLEM IS IN THE WIRING TO THE HUB.
THE RIGHT FRONT HUB USUALLY HAS A BEND, DOWNWARD THEN UPWARD NEAR THE CONNECTOR TO THE HUB. THAT IS WHERE THE PROBLEM USUALLY OCCURS.
NEW HARNESS WIRES CAN BE BOUGHT AT THE DEALER.
SOURCE: ABS light and trac control light off
YOU NEED TO HAVE ABS CONTROLLER SCANNED FOR DIAGNOSTIC TROUBLE CODES..THE SYSTEM HAS DETECTED A FAULT..A GOOD SCAN WILL YOU LEAD DOWN THE PATH TO FIXING THE PROBLEM..YOU CAN SEE IF WHEEL SPEED SENSORS ARE NOT WORKING,IF YOU CAN'T COMMUNICATE WITH CONTROLLER,ETC..LET ME KNOW WHAT IS FOUND
977 views
Usually answered in minutes!
×