At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Does it have play in north/south , or west/east direction? Get the bearings and tie rods checked depending on if play is up/down or right/left .... After fixing, get another alignment done if it is bad or if tie rods are replaced.
British Columbia is bordered by the Pacific Ocean on the west, Alaska on the northwest, and to the north by the Yukon and Northwest Territories, on the east by the province of Alberta, and on the south by the states of Washington, Idaho and Montana..
50 States in Alphabetical Order
Alabama
Alaska
Arizona
Arkansas
California
Colorado
Connecticut
Delaware
Florida
Georgia
Hawaii
Idaho
Illinois
Indiana
Iowa
Kansas
Kentucky
Louisiana
Maine
Maryland
Massachusetts
Michigan
Minnesota
Mississippi
Missouri
Montana
Nebraska
Nevada
New Hampshire
New Jersey
New Mexico
New York
North Carolina
North Dakota
Ohio
Oklahoma
Oregon
Pennsylvania
Rhode Island
South Carolina
South Dakota
Tennessee
Texas
Utah
Vermont
Virginia
Washington
West Virginia
Wisconsin
Wyoming
If it is a rear wheel drive predominately then yes you replace the front vac hubs only as the rear is constantly driving, is it a east west motor or north south , that will tell you a lot
if its Gen II, they have 4, mounted north east south and west on the bottom with one of which being a transmission mount. The Gen I or III's may have additional mounts at the top front of the engine known as "dog bones" because of their appearance.
Yes. Wish I could tell you which button for sure, but to reprogram the Compass you hold one of the buttons and drive in a circle one or two times to reacquire your position.
Spray some penetrating lubricant around all the edges of the rotor (front and back), give it about 25-30 minutes to soak in, and then go to town on it with a hammer banging on one side and then the other (North south, East west, South east north west etc)
there is a arrow on each cam lets call them north, you will also see marks at east and west to level cams, east and west need to be parallel were the head mets the valve cover while north points up done. Also there is a mark on the flywheel on the crank that needs to point north as well If you have the plastic cover on the lower you will see a plactic to line it up to.
×