SOURCE: can't find button under dash to reset/reprogram keyless entry
check this out - its not like the previous link - the button actually floats around with the wiring.
http://www.rs25.com/forums/showthread.php?s=8876327367f08262d9b387a75d9b5919&t=41265&page=2
SOURCE: Overheat on my 1997 Subaru Legacy GT
Sorry if this might break your heart. I have '98 Outback which is the same 1st generation DOHC 2.5 engine. These are common head gasket problem (I'd say 100% of every engine sooner or later) once you have had your car overheated.
You will not get this comfirmed by just have your mech check the compression on the cylinder because we call it phantom leak (internal leak which can be confirmed with hydrocarbon in coolant). And then you will end up replace every other thing before you could reach the source of problem.
Other signs of this issue are as following: random overheating after freeway or uphills drive, bubbles in coolant overflow tank, oil residue in coolant overflow tank, bubble nioses from the a/c vent.
You're looking at $1000-1500 repair by independent mech as they have to pull engine out to fix the problem. I had mine fixed two weeks ago and now my baby is running like a champ.
google for "Subaru head gasket problem"
SOURCE: where are the spark plugs in subaru legacy gt
Subaru's are horizontally opposed engines. This means that the cylinder heads are actually pointed out toward the wheels.
If you look out close to where the engine and the inner fender meet, just a little in going back to the center, you will find two on each side on the 2.5 non-turbo. These have plug wires going to them.
On a turbo, the plugs are actually right in the side of the engine, going into the tops of the cylinder heads below the ignition coils which you remove first, to get to them. The same is true with the 3.0 engine.
SOURCE: How do I reset factory alarm on a 2000 Subaru
you HAVE to get a remote and unlock the car.the dealer may be able to turn it off with the obd2 system,you have to call subaru.
SOURCE: I need to change the knock sensor on my 1998
sensor are located on mono fold pipe either before cat or after cat just unplug the sensor lead and use proper size wrench and remove sensor
122 views
Usually answered in minutes!
×