Where is the ignition control module located on a 1995 mercury sable 3.0 v6

Ignition control module ? Is there B+ voltage on the red an lit green striped wire at the ignition coil ? Watch this video on how to trouble shoot . This is a ford pick up ,ignition system similar . 1996 Ford 150 No Start with ScannerDanner EricTheCarGuy

HERE'S A LINK TO LOOK AT CLIFF. Where is fuel pump relay located on 1986 1995 Mercury Sable Ford Taurus

See attached video
Interior Fuse Box Location 1990 1995 Mercury Sable 1991 Mercury Sable GS 3...

MAke sure its in park( just move it though the gear shifts) sometimes the neutral switch gets sloppy age/usage/transmission swap etc. Check for voltage at the coil positive terminal when the ignition key is on. YES there is voltage, the problem is on the trigger side of the coil (pickup, crank sensor, ignition module or primary wiring circuit). If there is NO voltage at the coil, the problem is on the supply side (the ignition switch or ignition wiring circuit). Check Relays and Fuses.

possible causes, fan motor, fan relay, on no power in that circuit

The 1995 Sable uses the old OBD l PCM (powertrain control module). It is located under the dash behind the glove compartment. If you are removing the PCM the electrical connector is on the firewall inside the engine compartment. There is a small bolt in the connector that you loosen as the connector is being pulled out. If you are looking for the diagnostic connectors, they are on the passenger side near the firewall, in the engine compartment.

Ford Taurus/Sable 1986-1995 Repair Information
Fuse Panel and Fuses



Fig. 1: On most vehicles covered by this information, the fuse panel is located to the left of the steering column, attached to the instrument panel



Fig. 2: Fuse panel/block location-Early model Taurus shown



Fig. 3: Location of fuses and the circuits they protect-1995 vehicle shown

More details you can find in autozone.com (free register) with 46 wiring diagrams about Mercury Sable.

Hope helped with this (remember rated this help) Good luck.

remove distributor cap,check for moisture or poor condition of 'contacts' on rotor & inside cap.check for a clean connection at coil to distributor lead,check spark plug wires.

what engine? 3.0L 2 Valve? 4 Valve?
3.4L SHO engine?

The PCM (engine computer) fires the coils, but it is never the cause of a problem. I suspect it is the crankshaft position sensor on the front of the engine by the crank pulley. easy to change.

Crankshaft Position Sensor The crankshaft position sensor (CKP sensor) (6C315) is a variable reluctance sensor triggered by a 36-minus-1 tooth trigger wheel located on the crankshaft pulley and damper. The signal generated from the crankshaft position sensor is called the crankshaft position (CKP) signal, which provides base timing and crankshaft speed (rpm) information to the ignition control module (ICM) (12K072). Base timing is set at 10±2 degrees before top dead center (BTDC) AND IS NOT ADJUSTABLE. The powertrain control module (PCM) (12A650) will use this information with the spark advance information to determine ignition coil (12029) turn on or turn off time.

How do you change an ignition cylinder on a 1995 Murcury Sabel ? .