Brake lamp light on a 2002 Honda Accord SE

Majdi, if you mean the brake warning light in the dash is on after starting your car, the light is telling you there is a fault/problem with the braking system. You should not continue to drive if the brake warning light is on, as your brakes could fail. You will have to have a good shop check your brakes and diagnose problem and estimate repair. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Brake lamp warning light Honda Tech
Parking Brake Warning Light
What Causes the Brake Warning Light to Come on
http://honda-tech.com/honda-accord-1990-2002-2/%22brake-lamp%22-light-went-meaning-problem-1723211

Hi brian.
I think you mean P1362 and P1359
both fault codes are pointing to the crankshaft sensor.
check the wires/ connector. replace the crankshaft sensor.
Good luck

The brake lamp light simply means one of your brake lights is burned out and the battery light means your alternator is not producing the proper voltage and/or amps to correctly charge the battery.

If you mean running lights (not brake lights) check fuses first, then bulbs, wiring connection in trunk, light switch. If you mean brake lights, check fuses, brake switch at brake pedal, grounds at lamps, bulbs.

check the fuses. in cab fuse box. open glove box, read the operators guide, it shows the fuses and which is which. fix brakes first.

what country???????????
not working means little.
out or stuck on, is better./?

both brake lights. out?
both emerg. out all ends of ca?r x 4? front and rear.????
what about blinkers (turns).? out? x 4? front and rear?//????
there are 3 electric systems sold on this car.
one 1 has simple brake lamp switch, and the export is very complex.
ive not a clue what country you reside (or car was sold new)
so cant guess. or advice, beyond a fuse check.


but on 2 of the 3, cars
the wt/tan wire at the brake switch.
if 0v and the fuse is good, #2
then the switch is bad or maladjusted.
if wt/tan wire is 12v brake appled
then the wire is cut to the rear of car... lamps.(harness)
this is common with trailer wiring hacks (uhaul hacks)

You can try to replace all the brake lamp bulbs as sometimes eventhough all bulbs are working but one of them is about to blow and give high resistance. That's why the brake lamp lights up.

check your wire connectors where you ionstalled each bulbs. maybe loose.

it means your brake pads are worn and as a result your brake pad pistons have had to be displaced well enough to lower the level of brake oil in the brake oil make up tank. You may need to top up your brake fluid or replace your brake pads.

hi if its the red light symbol i would check your brake fluid level as it would put this light on if below minimum mark.

Do you have a users or ownerrs manual for this Honda? if so look in te glossary for rear lamps or tail lamps sub section fuses. probably the passanger side fuse box unless RHD then most likely drivers side