Rocker arm torque for a 91 s10 2.8 v6 pickup - S 10 Chevrolet Cars & Trucks

The 2000 Chevy Impala 3.4 liter engine rocker arm bolt torque specification is 45 pounds. The rocker arm bolts should be torqued in 15 pound intervals.

There is no adjustment , install rocker arms an torque to 18-28 lb/ft

start from the fan no1 ,3,5 and 2,4,6

Thank you for your service. There is a webside 60 degree v6 dot com. Try a search there. They have all of the torque specs for the 3400 the rockers torque to 14 foot pounds on those but they are aluminum. Are the rockers currently installed and you want to tear engine down? Measure the current torque. If it breaks, install a helicoil

https://www.google.com/search?q=Where+is+the+crankshaft+sensor+on+a+2003+Hyundai+santa+fe+2.4liter&biw=1360&bih=650&tbm=isch&tbo=u&source=univ&sa=X&ved=0ahUKEwjwgenro7HQAhUHNSYKHV8NBUkQsAQIJw#tbm=isch&q=Rocker+ARM+torque+for+3.5+Chevy+V6

Hope this helps

The bolt torque spec for the 3.0 Vulcan V6 rocker arms is 18-26 foot lbs, I always set it in the middle, so 22 foot lbs will do just fine. If I helped please rate me for fixya.com
Thanks

For each valve, rotate the crankshaft until the valve lifter rests on the heel (base circle) of the camshaft lobe. Position the rocker arm(s) over the push rods, then install the rocker arm seats. Tighten the rocker arm seat retaining bolts to 44 inch lbs. (5 Nm).

Final-tighten the rocker arm retaining bolt(s) to 19-25 ft. lbs. (25-35 Nm). For final tightening, the camshaft may be in any position.

Hope helps.

99 chevy malibu v6 3.1 engine, head bolt torque is-- 98 through 2001 is step1- 37 foot lbs, step 2- rotate an additional 90 degrees (1/4 turn). the rocker arm bolts are 168-in. lbs.

the rocker arm torque specs for the la1 gm 3400 sfi v6 is 168in lbs or 14ft lbs and 30degrees past that hope that helps you it came straight from my local dealer!

on 3.1 v6 it is--rocker arm bolts--- 89 in-lbs,intake manifold(lower)---step 1-62 in-lbs step 2 115 in-lbs. for year 1997 3.1,