1) Drain coolant
2) Raise and support vehicle
3) Remove the passenger side wheel and inner splash guard
4) Remove A/C compressor attaching bolts and position aside
5) Place a 1" wood block between the crankshaft and water pump pulley and remove water pump bolts and allow pulley to hang on pump hub
6) Remove water pump attaching bolts, then remove water pump and discard gasket
7) Reverse procedure to install
SOURCE: How do you replace water pump in 1999 saturn sl1?
View the video on You Tube by Richpin06a. It was very helpful. I don't do many repairs on cars, but with the help of this video, I replaced the waterpump on my Saturn last weekend. It was easy, and I didn't have to remove the engine.
SOURCE: water pump replacement ,1995 saturn sc 2 . pulley
a flat bar or screwdriver can be put across 2 bolts for leverage or wrap belt around pulley and pull tight for tension on pulley while loosening bolts
SOURCE: how to replace a water pump on a 1995 bmw 318is
-Disconnect the negative battery cable.
-Drain the cooling system.
-Remove the distributor cap and rotor. Remove the rotor adapter, the dust shield and the distributor housing.
-Remove the fan. The fan must be held stationary with tool 11 5
030 or some sort of flat blade cut to fit over the hub and drilled to
fit over 2 of the studs on the front of the pulley. Remove the fan
coupling nut; left hand thread-turn clockwise to remove.
-Remove the belt and pulley.
-Remove the rubber guard and distributor and or upper timing belt cover.
-Compress the timing tensioner spring and clamp pin with the proper tool.
*Observe the installed position of the tensioner spring pin on the water pump housing for reinstallation purposes.*
-Remove the water hoses, remove the 3 water pump bolts and remove the pump.
SOURCE: Install a water pump on 1995 Saturn
1) Drain coolant
2) Raise and support vehicle
3) Remove the passenger side wheel and inner splash guard
4) Remove A/C compressor attaching bolts and position aside
5) Place a 1" wood block between the crankshaft and water pump pulley and remove water pump bolts and allow pulley to hang on pump hub
6) Remove water pump attaching bolts, then remove water pump and discard gasket
7) Reverse procedure to install
SOURCE: How do you replace the water pump on a 1995 Saturn
it is under the timing chain cover. the serpentine belt and all that accompanying stuff has to be removed and/or disconnected. while you are doing this you may want to do the timing chain and sprockets too to avoid duplicating labor next year. The oil pump is also in there. This is a lot of work and not for the neophyte, the timing chain has to be put in maintaining proper relationship between the crank and cam shafts.
927 views
Usually answered in minutes!
×