Need to repair the EGR sensor. need location on the 4.7L Jeep Grand 2005
SOURCE: 2005 jeep grand cherokee limited 5.7 hemi vehicles hesitates
The egr valve is located on the front of the right cylinder head. It has a tube attached to it and going to the intake manifold.It has failed and is why your jeep is running rough and hesitating. Replace it and it will fix your driveabllity issues. Disconnect the battery for 2 min to clear the code.
SOURCE: LOCATION OF LIGHTER FUSE FOR 1996 JEEP GRAND
If you have the owner's manual look up fuses in the index, good illustration. If you don't, I do. It shows a relay and a 15 amp fuse. Look at the passenger kick panel, pull the cover, and it is #2 fuse (second from the top on the left) The see the relay you may have to pull the panel (two screws and a clip) the relay is the third cavity down, third row from the firewal side.
Let me know if this works for you?
SOURCE: location of crankshaft position sensor Jeep grand cherokee 1997
left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench,
SOURCE: crankshaft sensor located 98 jeep grnd cher 4wd 6cy
it is located at the back of the engine on top of the transmission bell housing,the plug runs over to the passenger side of the engine bay and it comes out from behind the engine,you can actually get your hand on the sensor itself from under the hood on the drivers side,and i believe its a 13mm bolt holding it in,the new sensor will have a sticker on the end of it...leave it there,it is used for correct spacing between the sensor and the flywheel,hope this helps
Testimonial: "Everything was just like you said but as a not atleast for my jeep it is an 11mm not 13mm. Works great so far (keep fingers crossed) "
38 views
Usually answered in minutes!
×