How many quarts of oil does the 4.6 liter V8 take?

About 9 quarts. If concerned, fill to 5 quarts and measure with dip stick. Keep adding until full. Then run the engine and check oil again, fill if needed.

Hello, this is the oil capacity of your vehicle.

I hope this info is helpfull

• with filter change

4.1 liters
4.3 quarts

• without filter change

3.75 liters
4.0 quarts

• 3.4L (LA1)

• with filter change

4.1 liters
4.3 quarts

• without filter change

3.75 liters
4.0 quarts

• 3.4L (LA1)

• with filter change

4.1 liters
4.3 quarts

• without filter change

3.75 liters
4.0 quarts

• 3.4L (LA1)

• with filter change

4.1 liters
4.3 quarts

• without filter change

3.75 liters
4.0 quarts

• 3.4L (LA1)

• with filter change

4.1 liters
4.3 quarts

• without filter change

3.75 liters
4.0 quarts

• with filter change

4.1 liters
4.3 quarts

• without filter change

3.75 liters
4.0 quarts
with filter 4.3 quarts

without oil filter 4 quarts

2.0 Liter engine = 3.76 Liters of oil (4 QUARTS)
2.5 Liter engine = 5.5 Liters of oil (5.8 QUARTS)

5qts normally you can find out from the counter guys when you buy oil and filter

With oil filter you'll need 5 quarts. After changing oil and filter run briefly and check for leaks. Shut down the engine and check oil level is correct.
I hope this may have helped,
Tom

Specifications Notes Use only Mercedes-Benz approved fluids

TYPE AF(DEXRON-II (R) Automatic Transmission Fluid) CAPACITY, Initial Refill*: 1982-85 190E 5.5 Liters 5.8 Quarts 1982-92 All w/V8 engines 7.7 Liters 8.1 Quarts 1986-91 190E, 260E, 300E 2.6L 6.0 Liters 6.3 Quarts 1986-91 300 Series 2.6L, except SL 6.2 Liters 6.6 Quarts 1990-91 300SL 6.0 Liters 6.3 Quarts 1992 600SEL 7.7 Liters 8.1 Quarts * Add specified quantity. With engine at operating temperature, shift transmission through all gears. Check fluid level in PARK, and add fluid as needed
diesel TYPE AF(DEXRON-II (R) Automatic Transmission Fluid) CAPACITY, Initial Refill*: 1984-89 190D Diesel 5.5 Liters 5.8 Quarts 1984-85 300 Series w/turbo 6.2 Liters 6.6 Quarts 1986-87 300 Series Diesel 6.2 Liters 6.5 Quarts 1990-93 300D Diesel 5.5 Liters 5.8 Quarts 1990-91 350SD, 350SDL Diesel 6.2 Liters 6.6 Quarts 1992-93 300SD Diesel 6.2 Liters 6.6 Quarts * With engine at operating temperature, shift transmission through all gears. Check fluid level in PARK, and add fluid as needed

I ~think~ the 1999 is the same as the 2000 (mine is a 2000 P71)

The 2000 CVPI (Crown Vic Police Interceptor) owners manual recommends the following:

Engine Oil - Motorcraft SAE 5W-30 Super Premium Motor Oil 5.0 quarts

Transmission Fluid - Motorcraft Mercon V ATF 13.9 quarts (fluids Mercon & Mercon V are NOT INTERCHANGEABLE, DO NOT MIX)

Fuel Tank - 19.0 gallons

Break Fluid - DOT 3


Rear Axle Lubricant - Motorcraft 80W-90 Premium Rear Axle Lubricant 3.75 pints (add 4 oz of Additive Friction Modifier C8AZ-19B546-A or equilavent meeting Ford Spec. EST-M2C118-A for complete refill of Traction-Lok Rear Axles)

Engine Data - 4.6L V8 Engine
Cubic Inches - 281
Required Fuel - 87 Octane
Firing Order - 1-3-7-2-6-5-4-8
Spark Plug Gap - 1.3-1.4 mm (0.052-0.056 inch)
Ignition System - Coil On Plug
Compression Ratio - 10.0:1

I hope this helps!

5 quarts

If your vehicle has the 5.2 liter,aka 318 cubic inch engine,there is only one transmission model applicable and it is the 42 RE which used to be designated the A500.It is a 4speed overdrive transmission.If installing a rebuilt trans and new remanufactured dry torque convertor.You add 4 quarts initially,then fire the engine and add another 5-6 quarts for a total capacity of 9-10 quarts.Fluid level is checked with the trans in Neutral.If you are only dropping the pan,you will replace roughly 4 quarts.The transfer case fills separately,but uses the same automatic transmission fluid.Capacity for the transfer case is about 2 quarts/fill to the bottom of the fill plug hole.Good luck.

Hello zimca,
I Take it the motor is a 5.7 liter v8 or a 4.3 liter v6 could even be the 5.0 but I would say that with the oil filter it should take 5.5 quarts of oil. some take 5 so after 5 start the engine for 15 seconds and shut it down and check it. As for the Ocatane I my self always run 92 octane I know it is more money but I have had less build up of carbon better running just all around better preformance. Its up to you though. so I hope that helps you out somewhat. Thanks for using Fix Ya Bear001