Flasher and flickers don't work - 2005 Chevrolet Aveo

Could be several things. But first make sure that the turn signal flasher is good. It is different than the 4 way/emergency flasher.

try to replace the flicker -flasher or relay, and test the bulbs too with the multimeter.

God bless you

You have lost a ground, and the brake lamps are grounding through the other lamps' elements. Check the grounds on both tail-lamps.

It's probably the turn signal flasher. It is usually located under the dash along with the hazard light flasher. If you don't know what it looks like, then go to a parts store and look at a new one. Once you have located one, then remove it. Try the hazard flashers. If they work, then replace that flasher with a new one. If they don't, then reinstall that flasher and look for another one like it. When you find one, replace it with the new flasher and try the turn signals. (remember : the key must be on for the turn signals to operate). I hope this information helps you and thank you for using Fixya.com.

since you know where the fuses are, you also know where the flashers are. the flashers are the same part so unplug the one for the emergency flasher and put it into the socket for the turn signals and vice versa. if the signals now work but not the emergency flasher you know to get a new flasher unit at any parts store. the flasher units are cubes about an inch on each side plugged into the fuse panel.

I assume you mean your signal lights when you say flicker lights? Your problem could either be a bad flasher unit or bad bulbs. I'd put my money on the flasher unit since none of the bulbs are flashing.

you don`t say but do the lights work either on the front/back on both sides.if not then it may be a fuse that needs replacing or need a bulb replacement.if the lights work but don`t flash then it sounds like a signal flasher problem.the flasher is located in the fuse panel under the dash on the drivers side.if the hazard flashers work then turn them on to find the hazard flasher by the fuse panel then you will know what the signal flasher looks like and change the signal flasher.make sure you change the one for the signals and not the hazard one.if the hazards work then i would say the signal switch is good as the hazards work through the same switch.

you need to check to see which bulbs don`t work both front and back lights for the signal on the side it`s not working,you don`t say if any signals work or not if no signals work then you need to check the fuses under the dash on the driver`s side.now if it`s just one side then check the lights as mentioned above.if one isn`t then replace the bulb.if neither bulb is working then it sounds like the signal flasher is not working.turn on the hazard flashers and check the lights front and back.if all bulbs work then leave the hazards on and look under the dash for the flasher that is making the noise,this will show what the signal flasher will look like,then find the signal flasher on the fuse panel under the dash it should be located on the fuse panel.and replace

If you turn sigals one or both dont work this could be a flasher ,,,change flasher not expensive.

first I would try replacing the flasher first, although I don't think it is the flasher it sounds like it;s the turnsignal switch or what they call the multi-function switch