I need a diagram of a 2000 cavalier on which wires go where for the spark plug wires i kno the firing order is 1 4 3 2

go to autozone.com, enter your vehicle info, they offer free diagrams

Firing Orders

• Firing Orders

Sending Units And Sensors

Starting System

• HOME /
• REPAIR HELP /
• 1996 CHEVROLET CAVALIER 2.2L SFI OHV 4CYL REPAIR GUIDE /
• ENGINE ELECTRICAL /
• FIRING ORDERS /
• FIRING ORDERS

GM Cavalier/Sunfire 1995-2000 Repair Guide

FIRING ORDERS

Print
See Figures 1 and 2
To avoid confusion, remove and tag the spark plug wires one at a time, for replacement.
If a distributor is not keyed for installation with only one orientation, it could have been removed previously and rewired. The resultant wiring would hold the correct firing order, but could change the relative placement of the plug towers in relation to the engine. For this reason it is imperative that you label all wires before disconnecting any of them. Also, before removal, compare the current wiring with the accompanying illustrations. If the current wiring does not match, make notes to reflect how your engine is wired.

Fig. Fig. 1: 2.2L (VIN 4) Engine Firing Order: 1-3-4-2 Distributorless Ignition System

Greg Bernett 2821 Solutions February 14, 2010
You didn't post your engine size so please pick the applicable diagram:



1996-98 4.3L Engines Firing Order: 1-6-5-4-3-2Distributor Rotation: Clockwise



1996-98 5.0L, 5.7L and 7.4L Engines Firing Order: 1-8-4-3-6-5-7-2Distributor Rotation: Clockwise




4.3L Engines Firing order: 1-6-5-4-3-2 Distributor rotation: Clockwise



4.8L, 5.3L and 6.0L Engines Firing order: 1-8-7-2-6-5-4-3 Distributorless ignition system (one coil on each cylinder)



5.0L, 5.7L and 7.4L Engines Firing order: 1-8-4-3-6-5-7-2 Distributor rotation: Clockwise

Source: spark plug wiring diagram for 98 tahoe

• 1

• 
  ledsled378 2926 Solutions July 24, 2010
  

..............................

Source: Need diagram for spark plug wiring for 1997 Chevy

Testimonial: "Thank you for your prompt response. Saved my husband from some distress!"
Was this solution helpful? Yes No

• 
  Dennis Weid. 44272 Solutions September 16, 2008
  

This was all I could come with, hope it helps.

Ok Gary I sent you two figures of a 2.2L and 2.4L engine I hope to serve you. Thanks

For 2000 Chevrolet Cavalier 2.2 liter L4 VIN "4" check...



or, for 2000 Chevrolet Cavalier 2.2 liter DOHC L4 VIN "T" check...



Good luck (remember rated this pots).

I can't upload the diagram but the firing order appears to be 1,4,6,3,2,5

Install the spark plug wire(s) (1, 3 and 5) to the engine right side spark plug(s).

Install the spark plug wire(s) to the retaining clips.

Install the spark plug wire(s) (2, 4 and 6) to the engine left side spark plug(s).

Install the spark plug wire(s) to the retaining clips.

You can get a copy of the service manual from Promanuals.net for cheap.

Here's a link to the firing order including a diagram: It's 1-2-3-4-5-6 Clockwise

http://www.chiltonlibrary.com/content/images/7922/images/79223G29.gif

Hope this answers your question. All the best!
Greg

FROM LEFT TO RIGHT, 5/2 3/6 4/1. ASSUMING YOU HAVE THE 3.1L ENGINE.

2.3 and 2.4 has idi ign.syst. mounted directly on top of plugs,2.2 coil pack cylinder numbers are marked on it,from left of elect. connector on coil pack is 2-3-1-4where spark plug wires go,on block, cyl. from drive belt side is 1-2-3-4,timing firing order is1-3-4-2