How do i put a serpentine belt on a 2004 ford taur...

Robert, Serpentine belt diagram. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
How To Install Replace Serpentine Belt Ford Taurus 3 0L V6 1AAuto com
2003 Ford Taurus V6 3 0L Serpentine Belt Diagrams serpentinebelthq com
2003 Ford Taurus Belt Diagram Am Having Problem Getting My

Go HERE, select your model and engine and it will take you to a belt diagram.

2004 Ford Taurus Workshop Repair Service Manual PDF Download

for better result of your problem contact the reliable-store they have the best service manual

Serpentine belt diagram 2002 ford taurus 3 0 2002 Ford Taurus
should be the same for 2003

go to u-tube and they will have videos on that I just did the same
thing with a ford taurs

The 8th digit of your car's VIN (vehicle identification number) tells you the engine
type for your car - your choices for Ford Taurus are U (3.0L), and S (3.0L).
I've included the Ford SHO engine too.




Serpentine belt for 3.0L (Vin U) Ford Taurus


Serpentine belt for 3.0L (Vin S) Ford Taurus


Serpentine Belt for Ford 3.4L SHO engine


Water Pump belt for Ford 3.4L SHO engine

REMOVAL AND INSTALLATION

1. Attach a 15mm socket or wrench to the bolt attaching the tensioner pulley.
2. On all 3.0L (OHV) engines, rotate the drive belt tensioner clockwise to relieve belt tension and slide the belt off the pulleys.
3. On 3.0L (DOHC) engines, rotate the tensioner counterclockwise to relieve belt tension and slide the belt off the pulleys.
   

To install:

1. Install the drive belt on all the pulleys except the tensioner pulley.
2. Rotate the belt tensioner as outlined in the removal procedure to relieve belt tension and install the belt onto the tensioner pulley. Make sure the V-grooves make proper contact with the pulleys. Make sure the spring keeper releases or improper belt tension will occur.

Tip: you may want to get (free) a serpentine belt installation tool kit to help with this job.
Both Advance Auto Parts and AutoZone wisely have loan-a-tool programs that permit you
to borrow (for a deposit) their serpentine belt installation kits - which allow their
handy customers to use their auto parts rather than towing it to a garage.

if you purchase your belt from Autozone or Napa the routing is on the back of the package

Most serpentine belt manufacturers Have the belt diagrams on the back of the package,I know auto zone and NAPA do

For the 3.0L Vulcan, you have a tensioner that is located just below the power steering pully. Use a 15mm wrench or the 15mm shallow well socket that comes in a Serpentine Belt tool to push the tensioner toward the rear of the engine compartment. Take the old belt off and route the new belt. The belt begins at the crankshaft pully, goes under and around the a/c compressor, up around the power steering pump, around (with the flat edge) the idler pully, around the alternator, the flat edge then sits against the tensioner and back around to the water pump pully. You should have a belt routing diagram on the underside of the hood just above the serpentine pully assembly.

hello two things you can do under your hood look very good ford usually has a routing diagram mounted on the top support of your radiator or off to the side it will be a pitcher of a front of a motor with pullys should show you with and without ac routing if not dont panic go to part store like auto zone get your self a haynes manuel that covers your year car the serpitine routine should be in there for your motor goodluck please rate