IMPORTANT NOTE: You must have the security anti-theft code for yours VW radio from the car manufacturer! For VW radio the sequence of programming is:
1. Push simultaneous "SCAN" and "RDS" keys until on the screen will appear "1000" displayed.
2. Release keys. No more push on "SCAN" and "RDS" keys because otherwise number "1000" will be considered as first safe code attempt.
3. By the #1 key you will set up the first safe code digit.
4. By the #2 key you will set up the second safe code digit.
5. By the #3 key you will set up the third safe code digit.
6. By the #4 key you will set up the four-th safe code digit.
7. Then push again simultaneous "SCAN" and "RDS" keys for confirm this safe code. On the screen will be displayed "SAFE" notice. Release keys! For few seconds a radio frequence will be displayed. The radio is now ready for use!
Most of the time the radio code is written down on the inside front or rear cover of the owners manual.
If that is not the case then hopefully you will be able to get the code from a Volkswagen dealership with only the VIN number to the vehicle, otherwise you will need to remove the radio to get the serial number from that radio in order to obtain the correct code from a Volkswagen dealership.
You will need to contact a Volkswagen dealership to find out which is applicable to your vehicle, and that is also the same way that any repair shop would obtain that radio code.
939 views
Usually answered in minutes!
×