P0460 - Fuel Level Sensor A Circuit
Description:
The powertrain control module (PCM) monitors the fuel level input (FLI) circuit for electrical failure. The test fails when the signal moves outside the minimum or maximum allowable calibrated parameters for a specified fuel fill percentage in the fuel tank.
Possible Causes:
Diagnostic Aids:
Monitor the FLI and FLI V PIDs in key ON, engine running. A concern is present if the FLI PID is at 25% fill and the FLI V PID is less than 0.90 volt with a non-matching fuel gauge or the FLI PID is at 75% fill and the FLI V PID is greater than 2.45 volts with a non-matching fuel gauge.
Application
Key On Engine Off
Key On Engine Running
Continuous Memory
Ranger
GO to Pinpoint Test HX .
All others
Refer to the Workshop Manual Section 413-01, Instrument Cluster for fuel level indicator diagnosis.
Your best bet would be to take it to a Ford dealer ,
P0700 Ford Transaxle Control System Malfunction
Possible causes Shorted or open circuit within Transmission Control Module (TCM) Faulty Transmission Control Module (TCM) What does this mean? Tech notes Since the P0700 is just and informative code, check the TCM for more codes to resolve the problem.
Read more: http://www.engine-codes.com/p0700_ford.html
SOURCE: 1997 Dodge Intrepid transmission slipping when warm
I was told to change my Transmission Control Module,located on the transmission . You can get it new for under $200 but, I was advised to get it from a junk yard it's alot cheaper and its easier. I hope this helps
SOURCE: my 2006 dodge 2500 with 48RE Transmission is not
I had the same problem, Replace the govenor pressure sensor. There is a TSB out for this as well, I replaced bolth sensors that are mounted in the valve body of the trans. When I did mine I also adjusting the bands and now it is like a new trans. It was not hard and all the information can be found by searching. I think the sensors ran about $148 for bolth. You will need to remove the trans pan to complete this job if you are doing this. Hope this helps out.
SOURCE: po700 trans error po732 gear 2 ratio incorrect
dodges do not have a strong transmission, I would be checking salvage yards for a replacement.
158 views
Usually answered in minutes!
×