2000 Jeep Grand Cherokee Logo

Related Topics:

Posted on May 11, 2017

2000 4.7 litre V8 Cherokee Laredo, hard start and loss of power.

2000 4.7 litre V8 Grand Cherokee Laredo, has had two new genuine fuel pumps in less than two years and had the filter/pressure regulator replaced. Goes well for a short time after fitment (this time only 6 months ). The tank has been cleaned also. It takes ages to start and stumbles then kicks into life and drives ok for a couple of miles then sudden loss of power and just crawls home. Has two fault codes of lean running logged. Only 30 psi at idle and virtually no flow and pressure drops to zero as soon as key is turned off.

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Feb 05, 2009

SOURCE: 2000 grand cherokee stalls

does it hesitate at 1500 RPM's???

Ad

Andy Lebel

  • 94 Answers
  • Posted on Oct 25, 2009

SOURCE: Q. Hi I have a 2000 Jeep Grand Cherokee, 4.0

Have you tried to switch your car on, wait 3 sec's and then start the engine? reason: If the pressure in the fuel system went down very fast, it need some sec's to arrive the pressure it needs to start. Also possible: switch on, wait 2 sec's, switch off, on and start. This does the same I told above. If that works, change the fuel pump or let this item checked be a specialist (it's expensiv to replace it).

Anonymous

  • 1 Answer
  • Posted on Dec 27, 2009

SOURCE: 94 Jeep Grand Cherokee is hard to start. If I turn

Has any one soled this yet???????? Because I have the the same prob. but mine is only when it is could out blow 65 it will start but I have to keep my foot on the gas like a carb with no choke

Anonymous

  • 5 Answers
  • Posted on Feb 16, 2010

SOURCE: hard starting jeep grand cherokee 2001 4.7 V8. new

who installed the CSM, sounds like it was installed incorrectly?

Also, are your battery connections tight?

Anonymous

  • 4088 Answers
  • Posted on Jul 18, 2010

SOURCE: Rough idle and stumble through acceleration. The

You need to check the fuel pressure to the throttle body. If the fuel pump is nearly worn out, it will display similar symptoms. Did you read out any codes on the computer before starting this repair? Good luck!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a 2000 grand Cherokee Laredo v8 all my brake lights went out checked the bulbs fuse and brake switch all are good the tail and signal lights are good. what should I do nextto fix the problem

Have you checked the brake light fuse to see if there is power at the fuse and out of the fuse, also check the brake light switch for power in and out when the pedal is pressed, do that and get back to me.?
0helpful
2answers

My car wont start after i changed the fuel filter wat is the problem 2000 jeep grand cherokee Laredo

keyon .off 5 times then start.
or crank for 5 seconds.
this will prime it
some cars dont prime with key on trick. only cranked.
1helpful
3answers
2helpful
1answer

2000 Jeep Grand Cherokee V8 Car will suddenly stall, fuel gauge down and won't start. Wait for about 1 hour or more, sometime less, fuel gauge comes on and engine starts. replace P0117, plugs, fuel...

Hello and welcome to FixYa!
I'm suspecting that the PCM (power train control module) is faulty. If the PCM is faulty the electrical fails at any given time. The PCM is like a car's brain, I strongly suggest that you have it replaced as a first course of action.
Hope this helps and thank you for using FixYa! Have a good one!
1helpful
3answers

I have a Jeep grand cherokee laredo and i have installed a new fuel pump and fuel filter but it will not start i have checked all fuses and relays please help.

Having same issue with my 2000 grand cherokee. sometimes fuel pump will prime and car starts the other 50% of time no fuel pump noise only smaller radiator fan will come on and make vibrating whining noise. I have changed out fuel pump and filter as well as checked and ruled out all fuses/relays involved. Need help too
0helpful
1answer

2000 Jeep Grand cherokee Laredo wont start. Engine turn over . No noise from fuel pump with ignition on. Replaced fuel pump and filter.Turn ignition on- pump did not run.Jumped the fuel pump at the pump...

sounds alot the the pcm it controls the fuel pump and ign system but the anti theft would keep it from starting because the key has a transponder in it programmed for that vehicle and that would kill all ign if triggered
0helpful
2answers

2002 Jeep GC Laredo: Starts up then stalls within seconds

Does the vehicle crank for extended period of time upon first starting? If so the fuel pump needs replacing.
0helpful
1answer

Fuel fileter

Get under the vehicle and start at the fuel tank and go forward you will find it. If its a Grand Cherokee Laredo the fuel filter is located inside the fuel pump so the whole fuel pump has to be replaced
Not finding what you are looking for?

131 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...