At times it starts fine other times the engine cranks fine but won't start. Other times while driving the engine will stop running. I replaced fuel filter, fuel pump, ignition coil, dist. Cap, rotor, plugs, wires. Need help please. Thanks
Since you now mention the check engine light, when you go to buy a manual and meter, have the codes scanned...most of the larger parts stores do that free. There is a list of codes in the manual. That will point you in the right direction. Ignore any O2 sensor codes to start with though as often any other malfunction can change mixture and set that code. Always deal with that code last.
Could be one of about three things. Could be Electronic spark control module, cam sensor or crankshaft position sensor. Is your service engine light on?
Testimonial: "The engine light is on. If I disconnect the battery it goes off untill I drive the car for approx. 3 miles then it comes back on"
It is a good idea as stated above to go ahead and put out the money which is generally around $20.00 for a Haynes or Mitchell repair manual from your local auto store and like stated above to purchase a ohm meter for any-wheres around $15.00 to $20.00. They will have trouble shooting for your specific problem generally in the books and will walk you through testing in Laymen terms so you can understand it.
Glad you got it fixed. thanks for the info back it helps us help other people as well.
×
283 views
Usually answered in minutes!
Thank you for your help. I am going to get a manual today and check the sensor
I am going to vet a manual so I can properly test the sensor. Thank you for your help!
It was the cam shaft position sensor Thank you for your help!
It seems that you have thrown parts at the problem without the benefit of any testing... that's called guessing. I strongly recommend that you get a chilton or haynes manual and a digital multi-meter and do some testing. Without the benefit of any testing, my guess is that there is a loose wire or poor connection somewhere or your crankshaft sensor is beginning to fail. But, I would not replace it unless I tested it first!
are you getting any codes??, also check your crank position sensor its very common on these and i just had to change mine
×