Cars & Trucks Logo

Related Topics:

Posted on Mar 03, 2018

1986 jeep cherokee laredo windshield wipers and turn signals wont work. checked fuses, checked power to fuse block, checked plug on lower steering column. Im getting power to the turn signal/wiper fuse of the fuse block with key on, but not a full 12V. What else could be the problem?

1 Answer

oldmechanic

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

New Friend:

An expert that has 1 follower.

  • Contributor 11 Answers
  • Posted on Mar 09, 2018
oldmechanic
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

New Friend:

An expert that has 1 follower.

Joined: Mar 13, 2010
Answers
11
Questions
0
Helped
1613
Points
23

On a 1986 jeep I believe it has a "wiper-turn-signal assembly" that is all part of the turn signal lever. (I think its a GM/Chevy style.) The new models have an assembly that's in the steering column behind the steering wheel. If I'm correct that its all part of the lever, that is almost definitely the problem - 98-99%. Pretty much the same answer for the newer versions also. I have replaced over a couple hundred in my "career". Keep smiling.

5 Related Answers

Anonymous

  • 319 Answers
  • Posted on Dec 20, 2008

SOURCE: 1996 jeep grad cherokee wiper fuse

either on the passanger side or under the hood behind the battery. open them up and read them. They will say which ones they go to.

Ad

Anonymous

  • 239 Answers
  • Posted on Dec 28, 2008

SOURCE: 2000 Jeep Cherokee Sport, window washing does not work

the little pump inside the washer fluid reservoir is bad, replace it

Anonymous

  • 1 Answer
  • Posted on Jan 15, 2009

SOURCE: 1998 Jeep Wrangler Electrical Short in Steering Column?

I had a similar problem with my 2000 Jeep TJ and I found the problem in the wiring harness under the hood.several wires were corroded and almost burnt off.If you remove the black tape which keeps the harness bundled together and if you see evidence of "green" type powder or "gook" it's most likely where the wires have faulted.

Anonymous

  • 3 Answers
  • Posted on Aug 12, 2009

SOURCE: windshield wipers stopped working on 1993 jeep cherokee

Did you plug them all back in? lol j/p

Do your blinkers and your back windshield wipers work? It's either electrical or mechanical. Turn them on and poke around to see if you hear the motor doing anything. If you hear it, it's probably a broken linkage. If not, start with the fuses and work from there.

It's possible that by unplugging the battery and then plugging it back it, the fuse for the wipers received an electrical surge, blowing it. Consult your manual to see where the fuse for your model is and check to see if it's blown.

Anonymous

  • 277 Answers
  • Posted on Aug 29, 2009

SOURCE: Steering column diagram needed for 1989 Jeep Cherokee

If you intend to keep the vehicle long term, I would suggest you invest in a Haynes Manual, That is worth its weight in gold, for this and any other project..
Regards,DT

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Where is the rear windshield wiper motor relay on a 1998 jeep grand cherokee laredo located ?

Has no relay . Has rear wiper module , part of the motor assembly . Check fuse's # 8 20 amp an #3 10 amp . the wiring diagram just show's junction block , must be inside fuse box . Check it out here http://www.bbbind.com/free_tsb.html free wiring diagrams .
0helpful
1answer

How do you troubleshoot 2000 Jeep Grand Cherokee Laredo front wiper blade

Check your manual for wiper fuse & relays location.You can inspect fuses visually...hope this helps
3helpful
1answer

What fuse is for the power door locks on a 2000 Grand Cherokee Laredo?

Check position F8 15AMP (Lt Blue) for Overhead console, rear wiper, IP lights, rear flipper glass solenoid, POWER LOCKS (click for zoom)...

zjlimited_779.jpg

This is located WJ Junction Block (under dash, left of steering wheel)...

zjlimited_780.jpg

Hope helps (remember to rate this answer).
0helpful
2answers

All turn signals on my jeep cheroke laredo are not working. Is the problem a bad fuse??

COULD BE BLOW FUSE.FAULTY TURN SIGNAL SWITCH OR FAULTY TURN SIGNAL FLASHERS WHICH IS LOCATED FUSE / RELAY BOX JUST LEFT OF THE STEERING COLUMN.
2helpful
1answer

Windshield wipers stopped working on 1993 jeep cherokee

Did you plug them all back in? lol j/p

Do your blinkers and your back windshield wipers work? It's either electrical or mechanical. Turn them on and poke around to see if you hear the motor doing anything. If you hear it, it's probably a broken linkage. If not, start with the fuses and work from there.

It's possible that by unplugging the battery and then plugging it back it, the fuse for the wipers received an electrical surge, blowing it. Consult your manual to see where the fuse for your model is and check to see if it's blown.
1helpful
1answer

'87 Cherokee no horn, turn signals, brake lights, wipers, blower

Pull the fuses and check the socket for power on the things that don't work. If there is no power at the fuse box there is a good change the stater igintion switch is toast. it is located on top of the steering colunm under the dash.usally less then 20 bucks All that you mentioned get power from this switch that goes to the fuse panel when you turn the key on
0helpful
2answers

Dash and shifter lights in 1996 jeep cherokee wont light

Hello and welcome to FixYa . Locate the dial that controls the brightness of the dashboardlights. If the control is not immediately evident. Make sure the brightness control is turned on. If it is and the lights aren't working, the problem may be a bad fuse. Check the fuse that controls the dashboard lights Replace the fuse if necessary. If just one part of the instrument panel is not lighting up, then you have either a burned-out bulb or a wiring problem.

Passenger side kick panel fuse breakdown for a 1996 jeep Cherokee Country

01 - 25A Rear Wiper/Washer
02 - 15A Radio, Cigar Lighter
03 - Empty
04 - 15A Passing Light
05 - 30A Blower Motor
06 - 30A (Circuit Breaker) Power Windows
07 - 02A ABS
08 - 20A Turn Signal Flasher
09 - 10A Radio/Clock Memory, Courtesy Lights, Glove Box, Cargo, Dome Lights, Telltales
10 - Empty
11 - 25A Headlamp Delay Module, Horn
12 - Empty
13 - 20A Power Door Locks
14 - Empty
15 - 15A Instrument Panel Lamps, Clock/Radio and Memory, Headlamp Switch, Parking Lamps
16 - 30A (Circuit Breaker) Power Seats, Trailer Tow
17 - 7.5A Instrument Cluster Gauges, Headlamp Delay Module, Chime Module, Overhead Console
18 - 25A Rear Defrost
19 - 05A Instrument Panel Lamps, Radio Illumination
20 - 5.5A (Circuit Breaker) Windshield Wipers and Washers

This should get you going. And you can always Ask Me.
0helpful
1answer

1997 jeep grand cherokee laredo - no turn signals.

Check your fuses the turn signal fuse could be blown.
2helpful
1answer

2000 Jeep Cherokee Windshield Washer

You have a motor for the front and rear washer. Check the fuses. If the intermitted wipers does not work, there is a relay under the dash near the steering colum that needs to be replaced.
Not finding what you are looking for?

345 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...