Only the 2.3 liter diesel is an interference engine. The 2.3 Liter gas is not an interference engine. I would guess the belt was not installed correctly. The belt broke so the cam was then out of alignment with the crankshaft. Unless you aligned it correctly it will not start. BTW, the belt must be replaced every 60,000 miles. I asume you have the timing cover off, put it back on and set the crankshaft at the 0 mark on the timing cover, remove the cover and don't touch the crank. near the bottom of the cam gear is a protruding piece of plastic with three raised areas, set the cam timing mark at the first pointer, closest to the passenger side . on the back part of the timing cover is a v shaped pointer set the distributor gear mark at the pointer, remove the distributor cap and verify that the rotor is pointing at #1. Loosen both bolts on the tensioner and using a pry bar carefully pry the tensioner away from the distributor gear, tighten the small bolt on the tensioner. install the new belt starting at the crank, then the distributor gear, then the cam, then over the tensioner pulley. loosen the small bolt and the tensioner will adjust automatically. tighten the tensioner bolts and turn the engine over by hand 2 or 3 times and make sure all marks line up ( the cam mark should now be at the center pointer with the crank at 0). I find it handy to paint a reference mark for the crank inside the timing cover.
505 views
Usually answered in minutes!
×