SOURCE: How to clean EGR valve passages in 1993 Isuzu Trooper DOHC V6
You have to the EGR valve (sometimes the Intake manifold to EGR Vlalve line also). After you remove it take a drill bit the about 20 % smaller than the actual hole of the outlet side and rotate the drill bit with your hand to dig out the carbon. Aditionally the line coming from the intake manifold to the EGR valve will clog near the connection to the EGR valve. I use either a single piece of copper wire or the wire that you would use to tie ribar together to clean the line. When your done cleaning take a piece of vacuum line and connect it to the diaphram side and **** on it... then plug the line well with your thumb. Grasp the valve and blow thru it... Air should blow thru it freely. Remove your thumb from the vacuum line and try blowing again.. No air should pass thru the valve.
Then reinstall the valve and start the vehicle with the vacuum line disconnected (but blocked off) Use another piece of vacuum line connected to the diaphram again and **** on the line.. The vehicle should die or run really bad. If it does this then you cleaned it correctly.
SOURCE: i have 3 codes p1125, p1295, and p1515 and was
p1125 tells you the vehicule has gone into (limp) mode or reduced power. p1295 will direct you to a problem with your Throtlle position sensor and p1515 fault indicates theres a problem with the corilation between throttle position and commande giving.
i own a 2001 rodeo LS 3.2L and had this codes show up. The machine had really bad idling and when accelerating quick after first start would go into limp mode and not pick up speed pass 50 kms. i tryed changing the throttle position sensor.. nothing. tryed changing the spark plugs and noticed they looked unusually white (engine running lean) i put injector cleaner in with i freash tank of gas thinking the injectors were dirty and it seemed to help. Next a changed the fuel filter which completly solved my problem. at the last oil change they told me they changed it but didn't the inside of the filter was rusted and clogged starving the engine of fuel.
Problem solve for 15 $ after you change your filter take it to and auto parts store with a computer to reset the engine lights
SOURCE: NECESITO AYUDA..PROBLEMA EN ISUZU RODEO 2000.
ami carro sele tiro un sello dela transmision y se tiro todo el aceite lo pare de manejar selo pusieron y ahora enlas suvidas pierde velosidad y prende la luz abs
1,600 views
Usually answered in minutes!
×