Hei har bytta Reim til dynamo + servo + Airc pumpe + alle løpehjul og strammehjulet, ca menn har Fremdeles en Ulyd v oppstart av motor i 1,5 min .. metallisk knattrelyd,, så blir borte, men kommer tilbake v bruk av Fex rattet
har bestilt tid for bytte av regreim og vannpumpe+ div strammehjul...
nå er denne bilen påkosta ca 140.000.-de 4 siste årene,SKAL selges...
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
CONDITIONS
DETAILS/RESULTS/ACTIONS
H1 CHECK THE DEACTIVATOR SWITCH CIRCUITRY
Speed Control Servo C122
Measure the voltage between the speed control servo C122 pin 9, circuit 307 (BK/YE), harness side and the speed control servo C122 pin 10, circuit 57 (BK), harness side.
Is the voltage greater than 10 volts?
Yes INSTALL a new speed control servo. REFER to Speed Control Servo in this section. REPEAT the self-test.
No GO to H2 .
H2 CHECK DEACTIVATOR SWITCH POWER
Deactivator Switch C1025
Measure the voltage between the deactivator switch C1025, circuit 10 (LG/RD), harness side and ground.
Is the voltage greater than 10 volts?
Yes GO to H3 .
No REPAIR the circuit. REPEAT the self-test.
H3 CHECK CIRCUIT 307 (BK/YE) FOR AN OPEN
Measure the resistance between the speed control servo C122 pin 9, circuit 307 (BK/YE), harness side and the deactivator switch C1025, circuit 307 (BK/YE), harness side.
Is the resistance less than 5 ohms?
Yes INSTALL a new deactivator switch. REFER to Speed Control Deactivator Switch in this section. REPEAT the self-test.
Disconnect the servo hose, remove 6 bolts, pop the pump off with harness bracket making a note of the bracket for refitting. Clean mating faces of pump & block, loosely assemble pump to block with new gasket and with harness bracket located under head of bolt noted during removal. Evenly tighten the bolts to depress the pump plunder and tighten finally to 25Nm. Reconnect the vaccum hose and secure with clip.
Check the wiring harness for a live>ground fault
maybe the live to the pump(s) rubbed hard against the chassis somewhere.disconnect the harness from the pumps along the chassis rail somewhere and put a fuse in again. keep following the harness back and disconnecting til the fuse sts good. U may need 3-4 fuses. at some point you sould locate the section where the live is grounding. be patient it may take a while to locate. be optimistic - it may only take a minute!
:) good luck, hope this helps
×