At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The torque spec for the main bearing caps on a 2.2 are 105 nm or 77
ft lbs all. But you know if your doing the crank there is a lot more to
it then the torque . The main bearing clearance is 0.0006 to 0.0019 and
the rod clearance is even tighter 0.00098 to 0.0031. the connecting rod 45Nm or 34 lbs ft i hope be help you
Well good luck
I need accurate torque specifications for rod and
I need accurate torque specifications for rod and main bearing caps for a 2.0 liter eclipse turbo 90 help plis
2 Different size engines for that year. If you have the 2.2 the main bearing caps are 70 ft/lbs (final torque) & the rod bearing caps are 38 ft/lbs (final torque). If you have the 4.3, the main bearing caps are 77 ft/lbs (final torque) & the rod bearing caps are 45 ft/lbs (final torque). I hope this helps and good luck.
CRANK SHAFT PULLEY BOLT TORQUE IS 83 FT LBS. MAIN BEARINGS TORQUE IS 48 FT LBS ROD BEARINGS TORQUE 23 FT LBS. YOU NEED A BEARING SEQUENCE GET PIECE OF PAPER WRITE NUMBERS 9 5 1 3 7 AND UNDER THIS NUMBER LINE NUMBERS UP ON EACH OTHER WRITE DOWN NUMBERS 8 6 2 4 10 YOU HAVE 10 CRANKSHAFT MAIN BEARING BOLTS. WHEN YOU LINE UP BOTH NUMBERS YOU WILL START TIGHTEN BOLTS 1 AND 2 TIGHTEN BOLTS 3 AND 4 TIGHTEN BOLTS 5 AND 6 TIGHTEN BOLTS 7 AND 8 TIGHTEN BOLTS 9 AND 10 YOU ARE TIGHTEN BOLTS IN A CRISS CROSS PATTERN. BESURE TO POUR OIL OR LUBRICATE CRANKSHAFT AND BEARINGS WITH CLEAN ENGINE OIL.WHEN YOU TORQUE MAIN BEARINGS TORQUE ALL THEM TO 20 FT LBS AND SECOND PASS TORQUE ALL BOLTS TO FINAL TORQUE 48 FT LBS. IF YOU RUN TO ANY PROBLEMS. YOU CAN BUY A HAYNES REPAIR MANUAL IT CAN HELP YOU.
The torque speic for the main bearing caps on a 2.2 are 105 nm or 77 ftlbs all. But you know if your doing the crank there is a lot more to it then the torque . The main bearing clearance is 0.0006 to 0.0019 and the rod clearance is even tighter 0.00098 to 0.0031. Well good luck
×