The box you're referring to is the "driver's side door control module" if it operates when you press on it you might just have a loose solder connection on the pins. Obviously, you've already removed the inner door panel, so...
1. Unhook neg batt cable
2. Loosen the top screw
3. Press the bottom retaining clips on both sides in and pull back, or just pull back, the screw holds it in and the slots keep the thing steady.
4. Refrain from smashing everything and burning the car to the ground
5. Lightly unclip the three clasps holding the control module board in its housing
6. Visually check for damage, discolouration, loose or broken connectors.
7. Repeat step 4 if you don't find anything
8. Multimeter check or
9. Online parts search
10. Forget step 4.?
SOURCE: 1999 lincoln fuel pump
My fuel pump on my 1998 Lincoln Continental has no power. I checked the fuse it is good. I checked the fuel shutoff switch it was fine. I have traced the wire from the fuel shutoff switch to the fuel module driver in the trunk. The wire has power. I have also traced the positve wire from the fuel pump to the fuel driver on a different terminal, this wire has no power from the pump. I also changed the fuel driver, the low fuel pressure switch, the alternator, and battery.does anyone have any suggestion's?
SOURCE: Location of the fuel filter in a 1999 Lincoln Towncar
It is either along the frame rail, probably drivers side under car follow the metal fuel line or it is in the gas tank right at the fuel pump, either requires removing tank or carpet inside trunk to get to access panel, but your problem is probably not fuel filter, with todays clean fuels fuel filters are a problem of the past, used to be a easy fix but that is why they hide them now because they are usually good for life of vehicle, 1999 is not old enough to make difference in this situtation.
SOURCE: HOW TO REPLACE INTAKE MANIFOLD ON A LINCOLN
answer , very carefully ...
drain coolant , remove and mark all vacuum lines , make a schematic to diagram your hose routing, disconnect and plug all fuel lines, remove distributor and mark location of rotor, disconnect battery, remove any necessary cables, brackets and or accesseries, remove intake mounting bolts, note length of bolts and reference location, pry up on intake , remove intake, scrape old gasket off , must be very clean to reinstall new gasket or you will cause a leak..
SOURCE: diagram of installation of serpentine belt on 1999
The diagram is under the hood near the radiator. If the factory sticker has been removed then a $25 repair manual at your local parts store will answer that and many more questions, well worth the cost, I get one for every car I own or intend to do much work on.
SOURCE: I need the fuse box diagram for a 2002 lincoln
if you have miss place your owner manual it should be on the cover telling you which one is give this website a try to see if you can download one www.edmunds.com if all fails stop by your local lincoln dealership in the parts department and they be able to print off the pictures and diagrams you will need wish you the best of luck Michigan Man.
234 views
Usually answered in minutes!
×