Serpentine belt diagram 1993 chrysler lebaron v6

You will find it on the Dayco web site and go through the steps Go to :

http://www.accessdayco.com/Auto.aspx

So here is the serpentine belt routing diagram:

Automotive & Light Truck Year 1992 Make CHRYSLER Type PASSENGER CARS Model LEBARON Engine V6 3.0L 2972cc 181ci GAS FI N 3 Available Parts Routing

Check this diagram (click for zoom)...

Fig. 9: Timing belt routing and timing mark locations

Hope helps (remember to rate this answer).

belt routing diagram 3.0 l v6

Congrats for having such a great car. We have one also, and it's like a tank, just keeps going and going strong!

Okay ... Usually the diagram is on the underside of the hood, or else on top of the radiator.

We had that problem a few years back, and the only place we saw a diagram was when the repair shop opened his catalog of belts.

I'm afraid you may have to go that way, too. The Serpentine Belt is a tricky one, and it must be replaced exactly right, or you're in deep yogurt.

Good luck,
-a.

This should do it.

1994 CHRYSLER LEBARON - V6 3.0L 2972cc 181ci GAS FI N 3

Belt Routing Diagram (Alt., P.S., Idler & Tens.)



From DAYCO Catalog

I hope help you with this. Good luck.

1994 CHRYSLER LEBARON - V6 3.0L 2972cc 181ci GAS FI N 3

Open the hood, the diagram for the serpentine belt is on the cowling.

From DAYCO Catalog
Belt Routing Diagram (Alt., P.S., Idler & Tens.)



From comments to other users and Lebaron Owners; for remove, starting at the alternator pulley and going clockwise around the pathof the belt, the belt drops down and forward and goes under the idlerpulley, continues forward and less steeply downward and goes around thecrankshaft pulley clockwise, rises rearward going over the top or thetensioner pulley counterclockwise, then drops down and around the powersteering pump clockwise and rises to go around the alternator pulleyclockise (which is where I started the description). To loosen thetension to remove the belt, or to give you slack to install the beltwithout having to force it over a pulley while under tension you rotatethe tensioner pulley arm around its pivot clockwise according to the'94 shop manual. It doesn't show by what means to effect this rotation,but in the earlier manual I have ('89) it shows there to be a 1/2"square hole in the tensioner arm into which you insert a breaker barwith a 1/2" square drive which gives you the temporary lever to rotatethe tensioner against its spring action. I assume there is a similar1/2" square hole on the '94 you are working with. Interestingly,between '89 and '94 the idler pulley was added, and the requiredrotation of the tension arm changed from counterclockwise to clockwiseto relieve the tension."

I think this will help you get the belt on. Good luck.

1992 CHRYSLER LEBARON - V6 3.0L 2972cc 181ci GAS FI N 3

Serpentine Belt Diagram Alt., P.S., Idler & Tens.



More details you can find in DAYCO Catalog

I hope help you whit this (remember rated this help) Good weekend.

Most parts stores can print this out for you for free.

go too auto zone and get a print out of it for free