SOURCE: Stuck in 5th gear
That just recently happened to me. If your stick wont move into any of the gears, then you need a clutch. But if you can shift into the gears but dont go anywhere, then you need a new transmission.
SOURCE: My 98 Escort ZX2 manual transmisson seems to shift gear hard!
Clutch may be smooth but this is a sign of the clutch needing replaced. Some of these models have a linkage adjustment under the hood. Others are hydrallic and need fluid. Look under the hood where the steering is and see which you have and address accordingly. Good luck. Check on costs of clutch replacement.
SOURCE: 5speed ford ranger problem is shifting
Sounds like your clutch is not releasing enough to allow you to engage or disengage. It is dragging which causes hard engagement and disengagement. Possible causes are, Low fluid in the master cylinder to the clutch, or bad slave cylinder down by the bell housing, or badly worn pressure plate, or air in the line leading to the slave cylinder. You will need to eliminate these items one by one by testing to find the bad item in the system. Good luck
SOURCE: won't shift out of first gear
good diagnosis that is correct if the vehicle speed sensor is not working the speedo doesnt work and the trans doesnt know when to shift
Testimonial: "EXCELLENT"
SOURCE: How do you remove the gear shift lever on a 93 ford ranger?
many of these trucks have a mazda trans in them, to remove these shifters you will need to remove the 4 phillips head screws from the corners of the trim around the shifter boot and pull it up out of your way. it's not necessary to remove the boot from the shifter, just lift it up for access to the top of the trans. at the base of the shifter on the top of the trans you will see a plate attached with torx head screws. remove all but 2 of them, now make sure the trans is in neutral and remove the last 2 screws and pull the shifter straight up. the shifter is now out leaving a big hole open on the top of the trans for dirt to fal into so put a wrag in it or screw a piece of cardboard to it. installation is the reverse. good luck
283 views
Usually answered in minutes!
×